Short Question Bank KEE 101/201 SET 2

1 The connection point of three or more elements is known as

A Node
B Terminus
C Combination
D Anode
2 An ideal voltage source has
A Very small internal resistance
B Zero internal resistance
C Infinite internal resistance
D Very high internal resistance
3 Superposition theorem can-not be applied for
A Voltage calculation
B Current calculation
C Power calculation
D None of the above
4 In the circuit shown, find the current IXY using superposition theorem

A 2.5 A
B5A
C 7.5 A
D0A
5. In the circuit shown, find the Thevenin’s voltage across terminals a & b

A 10 V
B 50 V
C 60 V
 D 40 V
6 For the circuit shown below the the value of Thevenin’s voltage and
resistance across A & B terminal is

A 0 Volts, 6 Ω
B 12 Volts, 6 Ω
C 12 Volts, 3 Ω
D 0 Volts, 3 Ω
7 The value of Norton resistance for the given fig across ab terminal is

A 14 Ω
B 20 Ω
C 3.33 Ω
D4Ω
8 The source transformation is applicable to
A Ideal source only
B Practical source only
C Both ideal and practical source
D None of the above
9. A nonlinear network does not satisfy
A Superposition condition
B Homogeneity condition
C Both homogeneity as well as superposition condition
D Kirchhoff’s Law
10 A delta connected load has each arm of value R/3. The resistance of the
each arm in star configuration will be
A 3R
B R/3
C 2R/6
D R/9
11 Q factor is defined as the
 𝜔0 𝐿
A
𝑅
1 𝐿
B √
𝑅 𝐶
ω0
C
𝛥𝜔
D All of the above
12 The value of resistance which must be connected in series with a 120 V,
60 W lamp in order to be operated at its rated current from 200 V, 50 Hz
supply is
A 100 Ω
B 160 Ω
C 200 Ω
D 80 Ω
13 The sign of inductive and capacitive reactance are
A both are positive
B both are negative
C inductive reactance is negative and capacitive reactance is positive
D capacitive reactance is negative and inductive reactance is positive
14 The parallel resonating circuit is also known as
A Tank Circuit
B Acceptor Circuit
C Rejector Circuit
D Filter Circuit
15 Two impedances Z1 = 5 + 5j Ω and Z2 = 5 - 5j Ω are in parallel. The total
impedance of the circuit is
A 0 + 5j Ω
B 5 + 0j Ω
C 10 Ω
D 7.07 + 7.07j Ω
16 In any given waveform
A The average value is always less or equal to rms value.
B The average value is always more or equal to rms value.
C The average value and rms value can-not be compare.
D The average value may be either more or less than rms value
depending on the waveform
17 In a RLC series resonating circuit, circuit resistance
A has no effect on the value of resonating frequency
B is inversely proportional to the selectivity
C is directly proportional to the bandwidth
D All of the above
18 The power consumed by a capacitor of capacitive reactance 10Ω
connected to a 100V, 50 Hz AC supply is
A 1 KW
B 0.707 KW
 C 1.414 KW
D 0 KW
19 The power factor of an AC circuit is given by
A ratio of Apparent power to Real power
B ratio of Apparent power to Reactive power
C ratio of Real power to Reactive power
D ratio of Real power to Apparent power
20 In a balanced three-phase star connected system, the relation between
phase and line parameter are
A VL = VP and IL = IP
B VL = √3VP and IL = √3IP
C VL = VP and IL = √3IP
D VL = √3VP and IL = IP
21 The operating principle of a Transformer is
A Principle of mutually induced EMF
B Principle of dynamically induced EMF
C Principle of self-induced EMF
D None of the above
22 Silicon steel is used in manufacturing transformer core because
A Low permeability
B Low hysteresis co-efficient
C Low reluctance
D Low retentivity
23 The transformer ratings are expressed in
A Volts
B Ampere
C KVAR
D KVA
24 Short-circuit test in a transformer is conducted on…. side at rated …..
A HV, Current
B LV, Current
C LV, Voltage
D LV, Current
25 The most likely value of no load power factor of a transformer is
A1
B 0.8
C0
D 0.2
26 The load impedance required to fully load a 1KVA, 200/100 V
transformer when load is connected to 100V side is
A 10Ω
B 40Ω
C 20 Ω
 D 30 Ω
27 The value of voltage regulation of an ideal transformer is
A1%
B0%
C 2.5 %
D Always negative.
28 In transformers when a current is shifted from primary to secondary
windings
A it is divided by K2
B it is multiplied by K2
C it is divided by K
D it is multiplied by K
29 The voltage regulation of a transformer having percentage resistive drop
1%, percentage reactive drop 5% and unity power factor is
A 3.8 %
B 2.2 %
C1%
D -2.2%
30 The phase difference between secondary line voltage and primary line
voltage of a 3 phase delta/delta transformer is
A 0 degree
B 30 degree lagging
C 30 degree leading
D (30±φ) where φ is power factor angle of load
31 Wave winding is preferred for
A high current machines
B low voltage machines
C high current and low voltage machines
D high voltage and low current machines
32 The nature of EMF induced in armature conductors is
A DC
B AC
C AC and DC both
D none of these
33 In which type of DC motor the field coils consist of a few number of turns
of thick wire
A DC Shunt Motor
B Separately Excited DC Motor
C DC Series Motor
D All of the above
34 In DC series motor the starting torque is directly proportional to
A square of armature current
 B the motor flux
C ratio of armature current and flux
D square root of armature current
35 A synchronous motor can operate at
A leading power factor
B lagging power factor
C zero power factor
D all of the above
36 A synchronous motor is running at 500 rpm with 50 hz. The number of
poles will be
A 12
B 10
C 14
D 16
37 When rotor of an induction motor is at standstill, the value of slip is
A1
B 0.5
C 0.8
D1
38 The relation between Synchronous speed (Ns), Actual speed of motor
(N) and Slip (S) is
A Ns = (1-S) N
B Ns = (1-S) / N
C N = (1-S) Ns
D N = Ns + S
39 in single phase induction motor centrifugal switch is connected in
A Both starting and running windings
B running winding only
C starting winding only
D none of above
40 The electrolytic capacitor can be used for
A Starting of single phase induction motor
B Running of single phase induction motor
C Both A and B
D Never used in single phase induction motor
41 The advantage of fuse over MCB is
A Supply can be restored without clearing the fault
B Any wire can be used as fuse wire
C It is economical than MCB
D Fuse wire can’t be use again
42 Earthing is done to
A Provide a low resistance path to fault current
 B Provide a high resistance path to fault current
C Balance the connected load in the system
D None of above
43 The ELCB operates when the
A current in line wire is equal to current in neutral wire
B current in neutral wire is not equal to the current in line wire
C current in line and neutral wire is zero
D current in neutral and line wire is maximum
44 The advantage of power transmission using underground cable is
A Longer life and reduced maintenance
B Conserve valuable land and prevention from accidents
C Weather proof operation
D All of the above
45 The Primary batteries have
A irreversible chemical reaction
B low self-discharge rate and discharge current
C low cost as compare to secondary batteries
D All of above
46 The one unit of electrical energy is equal to
A 1 KWH
B 3.6×106Joules
C Both A and B
D None of above
47 6 cells of 2V each are connected in parallel then the total voltage will be
A 12 V
B 6V
C2V
D3V
48 The backup of battery of 150AH connected to load of 90 watts and
supply voltage is 15V
A 10 hrs
B 15 hrs
C 20 hrs
D 25 hrs
49 A cell is discharged at a steady current of 4A for 10 hrs, the average
terminal voltage being 2V. To restore it to original state of voltage, a steady
current of 3A for 20 hours is required at an average terminal voltage of 2.4
V. The ampere-hour efficiency for this case is…….
A 80%
B 75%
C 66.66%
 D 60%
50 The watt-hour efficiency is also known as ………
A energy efficiency
B capacity efficiency
C power efficiency
D output efficiency