GPON – Basic Command OLT Huawei

That’s same like Topology Below :

There is Always OLT and ONT.

Okay , Here we go of some basic Commands At OLT Huawei.

Checking OLT Uptime

OL01#display sysuptime
System up time: 324 day 20 hour 55 minute 38 second

Checking OLT Board

OL01#display board 0
————————————————————————-
SlotID BoardName Status SubType0 SubType1 Online/Offline
————————————————————————-
0
1 H805GPFD Normal
2 H805GPFD Normal
3 H805GPFD Normal
4 H805GPFD Normal
5 H805GPFD Normal
6 H805GPFD Normal
7 H802SCUN Active_normal –> Control Module
8 H802SCUN Standby_normal –> Control Module

9 H805GPFD Normal
10 H805GPFD Normal
11 H805GPFD Normal
12 H805GPFD Normal
13 H805GPFD Normal
14 H805GPFD Normal
15 H805GPFD Normal
16 H805GPFD Normal
17 H801X2CS Normal –> Uplink Module

18 H801X2CS Normal –> Uplink Module

19 H801PRTE Normal
20 H801PRTE Normal
————————————————————————-

OL01#

Checking OLT processor and Memory per Slot

OL01#display mem 0/1

Memory occupancy: 33%

OL01#display cpu 0/1

Send message for inquiring board cpu occupancy successfully, board
executing…
CPU occupancy: 15%
OL01#

Checking OLT Temperature

OL01#display temperature 0
SlotID: 1 BoardName: H805 Temperature: 42C( 107F)
SlotID: 2 BoardName: H805 Temperature: 41C( 105F

Finding ONT by SN number

OL01#display ont info by-sn ABCDEF

—————————————————————————–
In Huawei port 1 = port 0 at system
F/S/P : 0/1/0 (remember) this ONT Meaning that locate at slot 1 port
0 onu id 2

ONT-ID :2
Control flag : active
Run state : offline
Config state : initial
Match state : initial
DBA type : SR
ONT distance(m) :–
ONT battery state :–
Memory occupation :–
CPU occupation :–
Temperature :–
Authentic type : SN-auth
SN : ABCDEF (HWTC-07930A53)
Management mode : OMCI
Software work mode : normal
Isolation state : normal
ONT IP 0 address/mask : –
Description : IRONMAN
Last down cause : dying-gasp –> down caused by dying gasp (dying-gasp
= ont off )

Last up time : 2016-11-11 17:52:08+07:00 –> Log Last Uptime

Last down time : 2016-11-15 09:23:27+07:00

Last dying gasp time : 2016-11-15 09:23:27+07:00
ONT online duration : –
Type C support : Not support
Interoperability-mode : Unknown

Checking ONT Status

OL01#display ont info 0 1 0 all

—————————————————————————–
F/S/P ONT SN Control Run Config Match Protect
ID flag state state state side
—————————————————————————–
0/ 1/0 1 ABCDEF deactivated offline initial initial no
0/ 1/0 2 REZABU active offline initial initial no —
0/ 1/0 4 BAREZU active online normal match no –> ONT online

Checking ONT History Logs

OL01#config
OL01(config)#interface gpon 0/1
OL01(config-if-gpon-0/1)#display ont register-info 0 1
——————————————————————————
Index : 10
Auth-type : SN-auth
SN : ABCDEF (HWTC-19698F53)
TYPE : 245H
UpTime : 2016-11-02 16:56:37+07:00
DownTime : 2016-11-04 07:52:15+07:00
DownCause : ONT dying-gasp
——————————————————————————
Index :9
Auth-type : SN-auth
SN : ABCDEF (HWTC-19698F53)
TYPE : 245H
UpTime : 2016-10-31 22:29:05+07:00
DownTime : 2016-11-02 16:42:36+07:00
DownCause : ONT dying-gasp
——————————————————————————
Index :8
Auth-type : SN-auth
SN : ABCDEF (HWTC-19698F53)
TYPE : 245H
UpTime : 2016-10-29 00:25:35+07:00
DownTime : 2016-10-31 22:13:03+07:00
DownCause : ONT dying-gasp

checking ONT mac address

OL01#display mac-address port 0/1/0 ont 2

———————————————————————–
SRV-P BUNDLE TYPE MAC MAC TYPE F /S /P VPI VCI VLAN
ID
INDEX INDEX
———————————————————————–
2389 – gpon aaaa-bbbb-cccc dynamic 0 /1 /0 2 2 122
2388 – gpon bbbb-aaaa-cccc dynamic 0 /1 /0 2 1 212
———————————————————————–
Total: 2
Note: F–Frame, S–Slot, P–Port, F/S/P indicates PW Index for PW,
A–The MAC address is learned or configured on the aggregation port,
VPI indicates ONT ID for PON, VCI indicates GEM index for GPON,
v/e–vlan/encap, pritag–priority-tagged,
ppp–pppoe, ip–ipoe, ip4–ipv4oe, ip6–ipv6oe

OL01#

Checking ONT power

OL01#config
OL01(config)#interface gpon 0/1
OL01(config-if-gpon-0/1)#display ont optical-info 0 all
—————————————————————————–
ONT Rx power Tx power OLT Rx ONT Temperature Voltage Current
ID (dBm) (dBm) power(dBm) (C) (V) (mA)
—————————————————————————–
4 -23.10 2.30 -24.21 56 3.260 13
6 -21.08 2.28 -21.49 44 3.240 13

Checking ONT Version

OL01#display ont version 0 1 0 4

————————————————————————–
F/S/P : 0/1/0
ONT-ID :4
Vendor-ID : HWTC
ONT Version : 49
Product-ID :4
Equipment-ID : 24
Main Software Version : V3R0
Standby Software Version : V3R0
OntProductDescription : EchoLife
Support XML Version : 1.3.
OL01#

Checking ONT IP (Routing Mode)

OL01#display ont wan-info 0/1 0 4
———————————————————————
F/S/P : 0/1/0
ONT ID :4
———————————————————————
Index :1
Name : OLT_C_INTERNET_DHCP_WAN
Service type : Internet
Connection type : IP routed
IPv4 Connection status : Connected
IPv4 access type : DHCP
IPv4 address : 1.2.3.4
Subnet mask : 255.255.255.0
Default gateway : 1.2.3.1
Manage VLAN : 212
Manage priority :0
Option60 : Yes
Switch : Enable
MAC address : BBBB-AAAA-CCCC
Priority policy : Specified
L2 encap-type : IPoE
IPv4 switch : Enable
IPv6 switch : Disable
———————————————————————
OL01#

Checking ONT port status

OL01#config
OL01(config)#interface gpon 0/1

OL01(config-if-gpon-0/1)#display ont port state 0 4 eth-port all

————————————————————————–
ONT-ID ONT ONT Speed(Mbps) Duplex LinkState RingStatus
port-ID Port-type
————————————————————————–
4 1 GE – – down –
4 2 GE 100 full up –
4 3 GE – – down –
4 4 GE – – down –
————————————————————————–
OL01(config-if-gpon-0/1)#
Checking ONT configuration

OL01#display current-configuration ont 0/1/0 4

#
[gpon]
<gpon-0/1>
interface gpon 0/1
ont add 0 4 sn-auth “ABCDEF” omci ont-lineprofile-id 5
ont-srvprofile-id 1 desc “HULK”
ont ipconfig 0 4 dhcp vlan 212 priority
ont internet-config 0 4 ip-index 0
ont wan-config 0 4 ip-index 0 profile-id 1
ont port route 0 4 eth 1 enable –> routing mode

ont port native-vlan 0 4 eth 2 vlan 122 priority 0 –> bridging mode

ont port native-vlan 0 4 eth 3 vlan 122 priority 0 –> bridging mode

ont port route 0 4 eth 4 enable –> routing mode

#
[bbs-config]
<bbs-config>
service-port 2677 vlan 212 gpon 0/1/0 ont 4 gemport 1 multi-service user-
vlan 212 tag-transform translate inbound traffic-table index 20 outbound
traffic-table index 20
service-port 2678 vlan 122 gpon 0/1/0 ont 4 gemport 2 multi-service user-
vlan 122 tag-transform translate inbound traffic-table index 0 outbound traffic-
table index 0
return
OL01#

Checking ONT Configuration per-Port

OL01#display current-configuration port 0/1/1

#
[gpon]
<gpon-0/1>
interface gpon 0/1
port 1 ont-auto-find enable –> Configuring this to detect your unregister ONU
automatically

Checking How many Services per-ONT

OL01#display service-port port 0/1/0 ont 4
{ <cr>|e2e<K>|gemport<K>|sort-by<K> }:

Command:
display service-port port 0/1/0 ont 4
Switch-Oriented Flow List
—————————————————————————–
INDEX VLAN VLAN PORT F/ S/ P
VPI VCI FLOW FLOW RX TX STATE
ID ATTR TYPE TYPE PARA
—————————————————————————–
2677 212 common gpon 0/1 /0 4 1 vlan 212 20 20 up
2678 122 common gpon 0/1 /0 4 2 vlan 122 0 0 up
—————————————————————————–
Total : 2 (Up/Down : 2/0)
Note : F–Frame, S–Slot, P–Port,
VPI indicates ONT ID for PON, VCI indicates GEM index for GPON,

OL01#

You can Ping From Your ONT :p

OL01#config
OL01(config)#interface gpon 0/1
OL01(config-if-gpon-0/1)#ont remote-ping 0 4 ip-address 8.8.8.8

OL01(config-if-gpon-0/1)#
—————————————–
ONT remote-ping information
—————————————–
F/S/P : 0/ 1/0
ONT-ID :4
ONT IP Index :0
IP address of ping : 8.8.8.8
Transmit packets : 4
Receive packets : 4
Lost packets :0
Lost packets ratio(%): 0
Min delay(ms) : 31
Max delay(ms) : 31
Average delay(ms) : 31
Error Code :–
—————————————–

Reboot ONT

OL01#config
OL01(config)#interface gpon 0/1
OL01(config-if-gpon-0/1)#ont reset 0 4

Reset Factory ONT

OL01#config
OL01(config)#interface gpon 0/1
OL01(config-if-gpon-0/1)#ont factory-setting-restore 0 4

How To Release Renew ONT as DHCP client

OL01#config
OL01(config)#interface gpon 0/1
OL01(config-if-gpon-0/1)#ont ipconfig 0 4 dhcp reset

Checking Rx Level For OLT Uplink

OL01#config
OL01(config)#interface giu 0/18
OL01(config-if-giu-0/18)#display port ddm-info 0
Temperature(C) : 38.640000
Supply voltage(V) : 3.260000
TX bias current(mA) : 38.000000
TX power(dBm) : 1.095110
RX power(dBm) : -14.659738
OL01(config-if-giu-0/18)#quit
OL01(config)#quit
OL01#

Reset Slot

OL01#config

OL01(config)#board reset 0/1

How To find ONT by Mac

OL01#display location aaaa-bbbb-cccc
{ <cr>|fabric<K>|ont<K> }:

Command:
display location 4cf9-5dd3-1914
It will take several minutes, and console may be timeout, please use
command idle-timeout to set time limit
Are you sure to query MAC address location ? (y/n)[n]:y
———————————————————————–
SRV-P BUNDLE TYPE MAC MAC TYPE F /S /P VPI VCI VLAN
ID
INDEX INDEX
———————————————————————–
5493 – gpon aaaa-bbbb-cccc dynamic 0 /6 /6 50 1 203
———————————————————————–

If U want to Explore More about other, My advice is using “?” symbol.