Scribd
Upload
34 views4 pages

Engineering Drawing (CSE)

Uploaded by

Johny Sk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
34 views4 pages

Engineering Drawing (CSE)

Uploaded by

Johny Sk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 4

Code No: ME1501 R14

I B. Tech. II Semester Regular Examinations, June 2015


ENGINEERING DRAWING
(Computer Science & Engineering)
Time: 3 Hours Max. Marks:
60

Note: Answer any Five Questions. All questions carry equal marks.

1. a) Construct a regular pentagon of 30mm side by any two different


met
hod
s
(6M
)
b) Draw a diagonal scale of R.F. = 3/100 showing metres, decimeters and
centimeters and to measure upto 5 metres. Show the length of 3.69
metres on it. (6M
)

2. Construct a parabola if the distance of focus from the directrix is 40 mm


and eccentricity is 1.Draw a normal and tangent at a point which is 52mm
from the focus. (12M
)

3. a) Draw the projections of the following points


i) Point A is 28mm above HP and 35mm behind VP.
ii) Point B is 40mm below HP and 22mm behind VP.
iii) Point C is in HP and 20mm in front of VP (6M
)

b) A point A is 30mm above HP and 40mm in front of VP. Another point B


is 60mm behind VP and 50mm below HP. Draw the projections of
the

points A & B keeping the projector distance as 100mm. Draw straight


lines joining front views and top views. (6M)

4. The projectors drawn from the H.T. and the VT. of a straight line AB are 80
mm apart while those drawn from its ends are 50 mm apart. The H.T. is 35
mm behind the VP. and the VT. is 55 mm below the H.P. and the end A is
10
mm below the H.P. Draw the projections of AB, determine its true length
and
inclinations with reference. (12M
)

5. Draw the projections of a rhombus having diagonals 125mm and 50mm


long, the smaller diagonal of which is parallel to both the principal planes,
while the other is inclined at 30 degrees to the HP. (12M
)

Page 1 of 2
6. A cone of base of diameter 50mm and height 70mm has one of its
generators
in HP and making an angle of 30o with VP. Draw the projections when the
apex is nearer to VP. (12M)

7. Draw the isometric view of the object shown in figure below. All dimensions
are in mm. (12M
)

8. Draw the following views for the object shown.


i) Front view
ii) Top view
iii) Left side view (12M
)
Page 2 of 2

You might also like