1. Which of the following does not need to be replace periodically?

a. Transmission fluid
b. Power steering fluid
c. Differential fluid
d. Brake and clutch fluid
2. Which of the following must be replace periodically?
a. Shock absorber
b. Brake pad and lining
c. Clutch release bearing
d. Grease for wheel bearing
3. Which of the following statements about periodic maintenance items is true?
a. Tire rotation is performed to equalized tire pressure
b. When brake fluid absorbs moisture from the air. Its boiling point rises
c. If air cleaner filter is not cleaned or replace periodically, it will become clogged
d. All of the bulbs of a vehicle have the same wattage regardless of the place where they
are used on the vehicle
4. Which of the following statements about automotive transmission fluid is true?
a. Normally, the level of ATF fluid not decrease
b. ATF can be used in place of manual transmission oil
c. If ATF is not replace there is greater shock when gas change, but fuel economy improves
d. Deterioration of ATF is proportional to the number of years used, so it is necessary to
replace it only at the specified time
5. Which of the following statement about a maintenance schedule is true?
a. For parts where deterioration can be judge by looking, there is no set
inspection/replacement schedule
b. Parts deterioration with distance driven. So all replacement parts on a vehicle are
replace according to distance driven
c. The inspection and replacement of vehicle parts is determined by a period of time
regardless of model or usage condition
d. Inspection/replacement schedule is set according to model and usage condition, so it is
necessary to perform an inspection/replacement as the specified distance driven or
period of time
6. Parts of steering system where toe-in is adjusted is the?
a. Tie rod end
b. Rack and pinion
c. Worn and taper
d. Worm and selector
7. Center wear of tire is caused by?
a. Over inflation
b. Under inflation
c. Excessive caster
d. Excessive camber
8. Inward tilting of the wheel viewed on the top of the wheel is called?
a. Positive caster
b. Negative caster
c. Positive camber
d. Negative camber
9. These are the signs of steering problems except?
a. Hard shifting
b. Breaking pull
c. Hard steering
d. Wander or pull
10. Feather-edge tire wear is caused by?
a. Over inflation
b. Excessive toe-in
c. Excessive caster
d. Excessive camber
11. Which of the following is not a part of rack and pinion type steering?
a. Rack
b. Tie rod
c. Pinion shaft
d. Sector shaft
12. What caused spongy brake pedal
a. Clogged brake lines
b. Air trapped in the system
c. Lack of fluid in the reservoir
d. Insufficient clearance between brake drum and lining
13. Which of the following is not a part of brake caliper?
a. Dust seal
b. Piston seal
c. Wheel boot
d. Bleeder screw
14. What type of braking system, where wheel cylinder is fitted?
a. Air brakes
b. Disc brake
c. Drum brakes
d. Electric brakes
15. A brakes pedal pulsation can be caused by?
a. A bent brake line
b. Worn brake pedal
c. Out-of-round brake drum or disc
d. Low fluid level in the master cylinder
16. Which of the following statements pertain to the brake construction. Select the statement
that is true?
a. Normally, the parking brake fixes in both front and rear wheels
b. The disc brake has the wear indicator to detect wear of the disc brake rotor
c. The drum brake pushes the disc brake pad to the brake drum so that the braking force is
generated
d. The disc brake pushes the disc brake pads to the disc brake rotor so that the braking
force is generated
17. The following statement refers to the brake system. Select the statement that is false?
a. The tires are the only parts of an automobile that come in contact with the road surface
b. The brake master cylinder converts the force that applied to the brake pedal into
hydraulic pressure
c. The proportioning valve distributes hydraulic pressure that acts on the brakes of the
front and rear wheels in order to obtain a stable braking force
d. The drum brakes stop the rotational movement of the wheels by using the friction that is
generated when the brakes pads are pushed against the drum
18. Select the appropriate one that is direct cause for the brake fluid inside the reservoir to
decrease?
a. Tire wear
b. Brake line damage
c. Piston seal damage
d. Disc brake pad wear
19. Which one of the following statement is true about the brake fluid?
a. Generally, the brake fluid is used as a clutch fluid
b. Even if a large amount of water is intermixed with the brake fluid, the boiling point
remains unchanged
c. There is no problem if the brake fluid spilled on the paint surface of a vehicle because
the brake fluid does not affect rubber or metal
d. Even if a brake fluid is mixed with another type of fluid with different boiling point, the
original boiling point will remain unchanged
20. What would be the cause if the brake pedal slowly moves all the way to the floor when
steady pressure is applied to it?
a. Fluid breaks in the system
b. Insufficient fluid in the system
c. Wrong adjustment of pedal freeplay
d. Excessive clearance between brake drum and lining
21. Which of the following is to stop the up and down movement of the suspension system?
a. Coil spring
b. Leaf spring
c. Torsion bar
d. Shock absorber
22. Symptoms of suspension troubles can be found in the following except in?
a. Brake
b. Clutch
c. Steering
d. Wheel alignment
23. Hydraulic device that helps control the up/down and rolling motion of a automobile body is
the
a. Coil spring
b. Torsion bar
c. Stabilizer bar
d. Shock absorber
24. Tools used in moving the tire up and down when checking ball joint wear in the?
a. Pry bar
b. Support stand
c. Ballpeen hammer
d. Coil spring compressor
25. The following pertain to the leaf spring characteristic and components. Select one that is not
related to the leaf spring characteristics or component:
a. Camber
b. Silencer pad
c. Inter-leaf spring
d. Unequal-pitch spring