Scribd
Upload
28 views3 pages

Manual Shifting Test: U140F Automatic Transaxle

Uploaded by

aaa aa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
28 views3 pages

Manual Shifting Test: U140F Automatic Transaxle

Uploaded by

aaa aa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

U140F AUTOMATIC TRANSAXLE – AUTOMATIC TRANSAXLE SYSTEM AX–21

MANUAL SHIFTING TEST


1. MANUAL SHIFTING TEST
HINT:
• Through this test, it can be determined whether the
trouble occurs in the electrical circuit or if it is a
mechanical problem in the transaxle.
• If any abnormalities are found in the following test, the
problem is in the transaxle itself.
(a) Disconnect the connector of the transmission wire.
HINT:
It is possible to deactivate the electrical shift control
by disconnecting the transmission wire. The gear
positions can then be changed mechanically with
the shift lever.
(b) Drive with the transmission wire disconnected.
Move the shift lever to each position to check
whether the gear position changes as shown in the
table below.
Shift Lever Position Gear Position
D 3rd
2 3rd
L 3rd
R R
P P

(c) Connect the connector of the transmission wire.


(d) Clear the DTC (see page AX-29).

C127583

AX
AX–22 U140F AUTOMATIC TRANSAXLE – AUTOMATIC TRANSAXLE SYSTEM

INITIALIZATION
1. RESET MEMORY
NOTICE:
• Perform the RESET MEMORY procedures (A/T
initialization) when replacing the automatic
transaxle assembly, engine assembly or ECM.
• RESET MEMORY can be performed only with the
intelligent tester.
HINT:
The ECM memorizes the vehicle conditions when the
ECT controls the automatic transaxle assembly and
engine assembly. Therefore, when the automatic
transaxle assembly, engine assembly, or ECM has been
replaced, it is necessary to reset the memory so that the
ECM can memorize the new information.
The reset procedures are as follows.
(a) Turn the ignition switch OFF.
(b) Connect the intelligent tester to the CAN VIM. Then
connect the CAN VIM to the DLC3.
(c) Turn the ignition switch ON and turn the tester ON.
(d) Enter the following menus: DIAGNOSIS /
ENHANCED OBD II.
(e) Perform the reset memory procedures from the
Engine menu.
CAUTION:
After performing the RESET MEMORY
procedures, be sure to perform the ROAD TEST
(see page AX-12) as described earlier.
HINT:
The ECM learns through the ROAD TEST.

AX
U140F AUTOMATIC TRANSAXLE – AUTOMATIC TRANSAXLE SYSTEM AX–23

Tester Menu Flow:

C115865E02

AX

You might also like