Scribd
Upload
10 views2 pages

Midterm 2018

Uploaded by

d15hb674
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
10 views2 pages

Midterm 2018

Uploaded by

d15hb674
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

/ Time: 2 hrs

Aljabal Algharbl University


Faculty of Engineering
Communication Engineering II
SECOND Midterm/ Spring 2018
10
1. for SSB-SC system, with a channel noise psd of 10· and a baseba nd sidgBnal
bandwidth 4KHz, the receiver output SNR is required to be at least 70 ·
(Mark: 3)
a) What must be the signal power Si at the receiver input.
b) What is the receiver output noise power No.
c) What is the minimum transmitted power Sr if the channel
transfer function is H,{w) = 10-4 over the transmission band?

1. A) A DSB_SC modulated signal is transmittd over a noisy channel, with the


power spectral density of the noise being as shown in the figure below. The
message bandwidth is 4 kHz and-tt,.: carrier frequncy is 200 kHz. Assuming
that the average power of the modulated wave is 10 watts, determine the
output SNR of the receiver.{Mark: 4)

10-6

---400-'---...1.o-----'4...
oo-·-f(kHz>
B) Let a message signal m{t) be transmitted using SSB modulation. The
power spectral density of m(t) is :
Ill
Sm(!)= a w'
0, ! Ills; w
o.w
2. where a and W are constants. White Gaussian noise of zero mean and power
spectral densit of r,/2 is added to the SSB modulated wave at the receiver
input. Find an expression for the output SNR of the reciever.(Mark: 3)

2. Given m(t)= sin 4000rrt, the frequency deviation constant equals 400,000rr
radians/sec/volt and the phase deviation constant equals 20 radians/volt.
(mark: 4)
i. Estimate the bandwidth of FM and PM?
ii. Repeat part (i) if the amplitude is doubled.
iii. Repeat part (i) if the message frequency is halved?
iv. Estimate FM bandwidth if m(t) = sin 20,000 rrt + sin 4000 rrt?

3. A) A modulating signal m(t) band limited to 4KHz is sampled at the rate of


8000 samples per second. The samples are quantized into 256 levels, binary
Time: 2 hrs

coded, and transmitted over a channel with s0 (w)=6.25x10" • Each received


7

pulse has energy Ep = 2x10·5 .(Mark: 3)


I. Find the output SNR.
11. If the transmitted power is reduced by 10 dB, find the new
SNR.

4. B) Consider a OM system designed to accommodate analog analog message


signal limited to bandwidth SKHz. A sinusoidal test signal of amplitude A= lV
and frequency f x = lKHz is applied to the system. The sampling rate of system
is SO KHz.(Mark: 3)
i. Calculate the step size 6. required to minimize slope overload? And
explain what is meant by slope overload?
ii. Calculate the signal-to-quantization noise ratio of the system for the
specified sinusoidal test signal?

Best of Luck

You might also like