0% found this document useful (0 votes)
17 views4 pages

Teldat 3ge Datasheet

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
17 views4 pages

Teldat 3ge Datasheet

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

The ultimate 3G peripheral for enterprise routers

“Enable your existing enterprise router with 3G connectivity, easily solving


coverage problems and minimizing installation costs”
1
The Teldat 3Ge is an external Interface Card (i.e. an external WIC ) that enables the
enterprise router with 3G. This cutting-edge peripheral does not require additional
Interface Card slots nor PCMCIA or USB slots in the router. The unique interface between
the Teldat 3Ge and the router is Ethernet.

But the Teldat 3Ge is not a router, it is the interface that grants the Wireless WAN access
to the router. The management of this new 3G interface is seamlessly integrated into the
router engine, so that the service intelligence offered by the router for the land-line WAN
service are fully available for the new Wireless WAN service. The standard-based
communication on Ethernet between the Teldat 3Ge and the router guarantees the
compatibility with a vast range of existing enterprise routers.

This innovative device offers an easy and cost effective solution


for boosting the 3G in indoor scenarios. Enterprise routers are
hosted in the Server Room or in the Data Center Room where
typically there is lack of 3G coverage or, if present, the radio
signal is not strong enough to guarantee broadband speeds at
high 3G frequency bands. Addressing this challenge, the Teldat
3Ge is placed outside the server room to the spot with the best
3G coverage and delivers the 3G service to the router over the
corporate Ethernet network. This new approach overrides the
need of expensive coaxial cables and repeaters to boost the 3G
coverage.

Some Teldat 3Ge models include a VoIP to GSM Mediagateway


so the office VoIP calls can be transmitted to the GSM network.
The firm not only benefits from a least-cost call routing policy,
but also its VoIP Disaster Recovery plan is improved with the
option of local VoIP call breakin/breakout into the GSM network
on emergency.

ADVANTAGES

Cost reduction and easy indoor 3G upgrade. No expensive coaxial wiring nor amplifiers is required to link the enterprise network
platform to the 3G antenna, just the existing firm’s Ethernet wiring.
Reuse of the enterprise router installed base. No need for free expansion slots in the router.
Compatible with third party enterprise routers. The standard-based communication with the router guarantees the compatibility
with a large range of third party enterprise routers.
Fully managed from the enterprise router engine. The Teldat 3Ge is fully configured and monitored from the router.
Ready for Converged Services. Flexible traffic flow distribution policies can be implemented in the router for the efficient use of the
router land-line WAN and Wireless WAN (Teldat 3Ge) resources. The Wireless WAN access can also be shared with Voice traffic,
2
thanks to the Teldat 3Ge Voice support for least-cost call forwarding and emergency call breakin/breakout during disasters.
Easy migration to future cellular technologies. The enterprise cellular technology is upgraded by just replacing the Teldat 3Ge.
Best in class Scalability. A single router can manage multiple Teldat 3Ge devices, allowing for the coexistence of independent
Wireless WAN services in the enterprise for Disaster Recovery.

1
WIC: WAN Interface Card
2
Voice support available on Teldat 3Ge/HSDPA models

Teldat 3Ge Datasheet v4.3. © Teldat, S.A. Page 1 of 4

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
APPLICATION SCENARIO
In the left figure the corporate branch office ADSL router is
equipped with a Teldat 3Ge. When the enterprise router
detects a failure in its Main Link, then it forwards the IP
traffic to the HSPA service.

A new virtual Point-to-Point interface is configured into the


router. Upon the successful attachment of the Teldat 3Ge
into the WWAN network, the negotiated IP address is
assigned to the router virtual interface. All the WWAN
service intelligence (IP forwarding, IP link quality supervision,
QoS, VPN, etc) is centralized in the router engine.

The right figure illustrates the Teldat 3Ge VoIP to GSM


Mediagateway capabilities. The enterprise router is featured
with a SIP Proxy and the Teldat 3Ge formats the VoIP call into
a GSM audio call.

The SIP Proxy serves the office call requests and forwards
them to the Central ToIP server or to the Teldat 3Ge so they
can be placed is GSM calls. The Teldat 3Ge can also receive
calls to its SIM card phone number and forward them inside
to the Proxy Server so they can reach the appropriate
destination.

Upon a significant degradation of the IP connection ot the


Central ToIP Server, the SIP Proxy Dial Plan is modified so all
external calls are sent to the Teldat 3Ge and converted to
GSM calls.

PRODUCT FEATURES
Auto-provisioning (No Teldat 3Ge manual programming required). A new Point-to-Point interface is configured into the router to
manage the Teldat 3Ge. When the Teldat 3Ge boots up, it receives the full Ethernet and 3G programming on DHCP.
Advanced 3G failure detection & reporting. Detection mechanisms based on control traffic flow tracking and inactivity timers,
permits the Teldat 3Ge to report back to the router the cause of the 3G failure.
Teldat’s World Class 3G diagnostics. The most complete radio interface monitoring information is available for an accurate service
quality audition and accounting, such as the signal strength history report on the past hour, the serving and neighbor cell received
instant power, transmission speed, detailed UTRAN info and AT Command Line Interface.
VoIP Mediagateway (SIP and RTP/RTCP to GSM audio).
Small form-factor, Desktop or wall mounted.
Powered by PoE (IEEE 802.3af) or by an external power supply (included).
3
SMA external antenna port allows for the use of a wide range of external RF antennas.
External SIM card tray with anti-theft protection.
TECHNICAL SPECIFICATIONS

General Hardware & Mechanical features


Interfaces and connectors Dimensions and weight
1 x 10/100 FastEthernet interface, POE 802.3af client, RJ-45F Length x Width x Height: 130 x 165 x 38 mm
1 x 3G interface (HSDPA, HSUPA or CDMA-EVDO, depends on model) Desktop or wall mounted form-factor
1 x SIM tray (HSDPA & HSUPA models) Approximate weight: 450 gr
4
1 x SMA port for radio antenna Environmental specifications
3 x status LEDs Temperature:
Power Supply Operating normally: -20ºC to 65ºC
12 VDC, 1500 mA; 3 mm connector jack (2 mm internal pin) Restricted operation: -30ºC to 75ºC
Includes an external universal transformer AC 110v – 220v; 50/60Hz Storage: -40ºC to 85ºC
PoE 802.3af Client Relative Humidity: 5% to 85%
POE 802.3af client in RJ45 FastEthernet connector Barometric pressure: 860 mbar to 1060 mbar
POE Class 0: 12,95W maximum

3
Teldat 3Ge/HSUPA models support Dual antenna for diversity
4
Teldat 3Ge/HSUPA models are equipped with 2 x SMA radio antenna ports for WWAN diversity
Teldat 3Ge Datasheet v4.3. © Teldat, S.A. Page 2 of 4

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
3G wireless-WAN Interface features

Teldat 3Ge/HSUPA Teldat 3Ge/EV-DO


GSM, GPRS, EDGE, CDMA 2000 1xRTT,
Technologies
UMTS, HSDPA, HSUPA EV-DO rev 0, EV-DO rev A
GSM/GPRS/EDGE: 850/900/1800/1900
Frequency Bands (MHz) CDMA: 800/1900
UMTS/HSDPA/HSUPA: 850/1900/2100
Diversity 2100/850 MHz N/A
TM
Baseband processor Qualcomm MSM7200 Qualcomm MSM6800TM
GPRS/EDGE: CDMA 1xEV-DO Rev A (IS-856-A)
Multi-slot class 12 DL up to 3.1 Mbps
CS1-CS4, MCS1-MCS9 UL up to 1.8 Mbps
CDMA 1xEV-DO Rev 0(IS-856)
Data services (PS)
HSDPA Cat 8: 7.2 Mbps DL, 384 kbps UL DL up to 2.4 Mbps
UL up to 153.6 Kbps
HSUPA Cat 4: 2.0 Mbps UL CDMA 1xRTT (IS-2000)
DL and UL up to 153.6 Kbps
CSD 64 Kbps DL and UL N/A

Software features
WWAN features Management
5
Automatic handover SMS-based management protocol
3G failure detection based on packet tracking & inactivity timers Zero-configuration
Instant bitrate TFTP firmware upgrade (Teldat 3Ge and 3G module)
GSM Data calls (CSD) Authenticated DHCP client
Real-time WWAN monitoring: RSSI serving & neighbor cells Command Line Interface
UTRAN info, module info, etc. Telnet and Web servers for monitoring purposes
Detailed WWAN information right into the router CLI Event Logging System for detailed troubleshooting
Historical RSSI report in the past hour
6
AT Command Line Interface Voice features
GPRS/3G Dual-context (depends on the model) SIP Gateway
RTP,RTCP
G.711 coding
The Teldat 3Ge is an external interface card. All communication protocols and functionalities supported by the existing router can be
seamlessly applied on this new interface, such as Quality of Service, VPN and Security features, queuing algorithms, interface monitoring and
statistics, etc.

THIRD-PARTY ROUTER COMPATIBILITY CHART

The following table gives an orientation on the different Cisco router models and software versions that interoperate with the Teldat 3Ge.
Model IOS Min Feature Set Memory (RAM/FLASH) Comments
836/837 12.3(2)XA IP/FW 3DES 32MB / 8MB TCL not supported

S870ASK9-12402T
87x 12.4(2)T Advanced Security 128MB / 24MB
Advanced Security is the basic Feature Set for the 870 series

S180BB-12404T
180x 12.4(4)T IP Broadband 128MB / 32MB
IP Broadband is the basic Feature Set for the 180x series

Advanced IP Services is the basic Feature Set for the 181x


1811/1812 12.4(2)T Advanced IP Services 128MB / 20MB
series

12.3(8)T4 IP Base 128MB / 32MB S184IPB-12308T


IP Base is the basic Feature Set for the 1841 series
1841 12.4(2)T1 Enterprise Base 128MB / 32MB S184EBK9-12402T
12.4(2)T1 SP Services 128MB / 64MB S184SPSK9-12402T
S186SPSK9-12411XW
1861 12.4(11)XW4 SP Services 256MB / 128MB
SP Services is the basic Feature Set for the 1861 series

S280IPBK9-12402T
2801 12.4(2)T1 IP Base 128MB / 64MB
IP Base is the basic Feature Set for the 2801 series

5
Feature under development
6
Only for voice models

Teldat 3Ge Datasheet v4.3. © Teldat, S.A. Page 3 of 4

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
S28NIPBK9-12402T
2811/2821 12.4(2)T1 IP Base 256MB / 64MB IP Base is the basic Feature Set for the 2811, 2821 and 2851
/2851 series

ORDERING INFORMATION

Part no. Teldat 3Ge Model HSUPA (embedded) EV-DO (embedded) 3G-USB dongle

RWAEH1U2 TELDAT 3Ge/HSUPA 


RWAEH1U3 TELDAT 3Ge/HSUPA V+D  (GSM voice support)
RWAEH1C1 TELDAT 3Ge/EV-DO 
RWAEHUSB TELDAT 3Ge/USB 

Part no. Wireless-WAN antennas & accessories


RWAEAAM1 MULTI BAND 900-1800-2100 3G DIPOLE ANTENNA, 90 DEGREES MOUNT
RWAEAAM2 MULTI BAND 900-1800-2100 3G DIPOLE ANTENNA, MAGNETIC BASE MOUNT, 1.5M CABLE
RWAEAAM3 MULTI BAND 900-1800-2100 3G DIPOLE ANTENNA, CEILING MOUNT
RWAEAAM4 CDMA MULTI BAND 800-1900 DIPOLE ANTENNA, 90 DEGREES MOUNT
RWAEAAM5 MULTI BAND 900-1800-2100 3G DIPOLE ANTENNA, WALL MOUNT, OUTDOORS, 5M CABLE
RWAEAAM6 MULTI BAND 900-1800-2100 3G DIPOLE ANTENNA, WALL MOUNT, OUTDOORS, 10M CABLE
RWAEAEM1 EXTENSION BASE FOR MULTI BAND 900-1800-2100 3G ANTENNA, SMA CONNECTOR

TELDAT DOCUMENTATION
This datasheet shall be used only for information purposes. Teldat reserves the right to modify any specification without prior notice.
All trademarks mentioned in this document are the property of their respective owners. Teldat accepts no responsibility for the accuracy of the information
from third parties contained on this document. Code updates will be available as new functionalities are developed.

Teldat 3Ge Datasheet v4.3. © Teldat, S.A. Page 4 of 4

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

You might also like