Scribd
Upload
49 views10 pages

Installation Procedure of Centos

Installation procedure of Centos Bits In Byte

Uploaded by

rahul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views10 pages

Installation Procedure of Centos

Installation procedure of Centos Bits In Byte

Uploaded by

rahul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 10

From scratch installation procedure of

Centos 7

1] Insert CentOS install disk and start the computer. Then, following screen is displayed, Push Enter
key to proceed.
2] Select the language you'd like to use during the installation.

3] This is the default screen for some basic configuration. First, set time zone, click the
[DATE&TIME] icon.
4] Click a point on the map you'd like to set your time zone and push [Done] button which is on
the upper left.

5] Back to the default screen. Next, click the [KEYBOARD] icon.


6] Click [+] button on under-left to add another keyboard type for your language.

7] Select your keyboard type and click [Add] button.


8] After adding keyboard layout, send up your keyboard on the top for 1st priority like follows and
click [Done] button which is upper left to finish.

9] Back to the default screen. For [SOFTWARE SELECTION], it's OK to keep default because it had
better to install with [Minimal Install] for initial installation. Next, click the [INSTALLATION
DESTINATION] icon.
10] Select installation disk. Click the disk icon you'd like to install and next, click [Done] button on
upper left to proceed. If you'd like to customize partition layouts, check a box [ I will configure
partitioning] and proceed.

11] Back to the default screen. click the [NETWORK & HOSTNAME] icon.
12] Input any hostname you like in [Hostname] field and click [ON] button on upper-right to
enable networking.

13] Click [Done] button which is upper left to finish.

14] If it's OK all, click [Begin Installation] and proceed to next.


15] Installation starts and required to set root password and to create a common user. Click the
each icon and move to configuration.

16] On the root password settings, input any password you like and click [Done] button to finish as
follows.

17] On the common user settings, input any user name and password you like and click [Done]
button to finish as follows.
18] After finishing installation, click [Reboot] button.

19] After rebooting, login prompt is shown like follows. login with root user and password you set
during installation. Installing CentOS completes if you can login normally.

CentOS Linux 7 (Core)

Kernel 3.10.0-862.el7.x86_64 on an x86_64

localhost login:

You might also like