Scribd
Upload
55 views4 pages

ADAM-6066 For HiPAP Hull Unit

Uploaded by

w01010665188
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
55 views4 pages

ADAM-6066 For HiPAP Hull Unit

Uploaded by

w01010665188
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

ADAM-6066 configuration for HiPAP hull unit

Product:
Produkt: HiPAP mk II
Product reg.no: Rev.A Created by:
Produkt reg.nr: Rev.A Laget av: KVG
Doc.reg.no: Rev.A Controlled by:
Dokument reg.nr: Rev.A Sjekket av:
Doc.archive no: Rev.A Approved by:
Dokument arkiv-nr: AA000 Rev.A Godkjent av:
Revision:
Revisjon: A B C D E F

Date: 23.Mar.
Dato:
09

Contents

1 DOCUMENT HISTORY ................................................................................................. 2


2 SOFTWARE CONFIGURATION .................................................................................. 2
3 APOS/ACS TEST.............................................................................................................. 4

Page 1 of 4
1 DOCUMENT HISTORY

Rev Description of changes Created by


A Original issue KVG

2 SOFTWARE CONFIGURATION
The default IP address of the ADAM 6066 is 10.0.0.1. The IP address and subnet mask of the
configuration computer must therefore be changed. Open network connections right click on
the network adapter and select properties. Select the Internet Protocol and select Properties.
Configure the IP address like this:

Press OK twice.

ADAM-6066 configuration for HiPAP hull Unit/ Rev.A / Page 2 of 4


Download and install ADAM 5000 TCP-6000 utility.
http://support.advantech.com/support/DownloadSRDetail.aspx?SR_ID=1-8NX0J
Start the ADAM 5000 TCP-6000 utility. The utility should now find the module:

Click on 6066 in the left view.


Click on the IP address in the left view. ((10.0.0.1) – (ADAM-6066)
Click on the network tab and set the IP address to 192.168.127.125 and the subnet mask to
255.255.0.0 for the module that shall be used for hoist controll. Use subnet mask 255.255.0.0. in
all cases.

Press Apply. The default password of ADAM-6000 is “00000000”.

ADAM-6066 configuration for HiPAP hull Unit/ Rev.A / Page 3 of 4


The IP address and subnet mask of the configuration computer must be changed again. Open
network connections right click on the network adapter and select properties. Select the Internet
Protocol and select Properties.
Configure the IP address back to the original settings:

3 HIPAP TEST
Start APOS and HiPAP . Log on as service in HiPAP. Select Configure -> System
configuration. Enter the IP addresses as shown below; Make sure both are enabled.

Verify that APOS gets a toolbar Icon for the hull unit. Also verify that messages are sent from
HiPAP to APOS with Hullunit information and sluice information.

ADAM-6066 configuration for HiPAP hull Unit/ Rev.A / Page 4 of 4

You might also like