TECHNICAL SPECIFICATIONS

Technical Data D10-SMART D10 TURBO-SMART

Input voltage 90V - 240V AC +/-10% @ 50Hz1
Current consumption (Mains) 250mA
Battery charger current output 1.8A @ 27.4V +/-1%
Maximum number of operations per day 7503,6
Duty cycle - Mains present 2,3
45% 25%
Motor voltage 24V DC
Motor power supply Battery-driven (Standard Capacity - 2x 12V 7.2Ah)
Current consumption (motor at rated load) 8A 10A
Input / Output sink currents (Max accessory current draw)
I/O 1-4 100mA (12/24V)
I/O 5 and 6 3A (12/24V) 10sec Pulse
Motor push force - starting 40kgf 24kgf
Motor push force - rated 30kgf 18kgf
Gate mass - maximum 1000kg 250kg8
Gate length - maximum 50m 50m
Gate speed (varies with load)4 Up to 26m/min4 Up to 45m/min8
Manual Override Lockable with key release
Drive Pinion 17T Module 4 20T Module 4
Operations in standby with 2x 7Ah batteries Operating Modes
Power Saving Normal Power Saving Normal
15m/min 26m/min 15m/min 45m/min
15kgf 15kgf 9kgf 9kgf
Half day2,5,6 118 63 189 130
Full day2,5,6 93 50 150 104
Collision Sensing Electronic
Operating temperature range -15°C to +50°C
Onboard receiver type Code-hopping multichannel receiver with selective add and delete
Receiver code storage capacity 1500 Remotes7
Receiver frequency 433.92MHz
Degree of protection IP54
Mass of unit packed (with standard kit, but
13kg 13.5kg
excl. rack and battery)
Packaging dimensions (with standard kit, but
excl. rack and battery) 350mm wide x 282mm deep x 470mm high

1. Can operate off a solar supply, consult your local dealer for assistance 5. Can increase battery capacity for longer standby times
2. Based on 25°C ambient temperature and unit not in direct sunlight 6. Based on 4m gate, excluding all accessories
3. Based on a motor push force of less than 50% of rated (Starting and Running forces) 7. Multiple buttons per remote can be used
4. Gate opening and closing speeds can be configured to run slower depending on the 8. Refer to the table below for D10 TURBO SMΔRT’s recommended gate speed
requirements of individual installations for specified gates masses

OVERALL DIMENSIONS RECOMMENDED SPEEDS AND GATE

MASSES FOR THE D10 TURBO SMΔRT1
Max Speed (M/Min) Gate Mass (Kg)
45 250
41 300
36 400
390mm

32 500
29 6002
27 7002
25 8002
24 9002
64mm

23 10002

1. If a D10 TURBO SMΔRT is used on a gate over 250Kg, the speed must be reduced
28mm 205mm 295mm according to the table above to ensure that the gate can be safely stopped in an
emergency.
2. Centurion Systems (Pty) Ltd recommends the use of a D10 SMΔRT for gates over 500KG.