8. G Sensor • Since G sensor is a unit with the bracket, do
not disassemble them. A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the console box. <Ref. to EI-53, REMOVAL, Console Box.> 3) Disconnect the connector from G sensor. 4) Remove the G sensor from body. CAUTION: • Do not drop or bump the G sensor.
ABS00463
B: INSTALLATION Install in the reverse order of removal. CAUTION: Do not drop or bump the G sensor. Tightening torque: 7.5 N⋅m (0.76 kgf-m, 5.5 ft-lb) C: INSPECTION Step Check Yes No 1 CHECK G SENSOR. Is the value −1.2 — 1.2 m/s2 Go to step 2. Repair the har- 1) Turn the ignition switch to OFF. when the vehicle is in horizon- ness connector 2) Connect the Subaru Select Monitor to data tal position? between G sensor link connector. and ABSCM&H/U. 3) Set the Subaru Select Monitor to the {Brake Or replace G sen- Control} mode. sor. 4) Set the display in the {Current Data Display & Save} mode. 5) Read the G sensor output value. 2 CHECK G SENSOR. Is the value 8.1 — 11.2 m/s2 Go to step 3. Repair the har- 1) Remove the console box. when G sensor is inclined for- ness connector 2) Remove the G sensor from vehicle. (Do not ward to 90°? between G sensor disconnect connector.) and ABSCM&H/U. 3) Read the Subaru Select Monitor display. Or replace G sen- sor. 3 CHECK G SENSOR. Is the value −8.1 — −11.2 m/s2 G sensor is nor- Repair the har- Read the Subaru Select Monitor display. when G sensor is inclined mal. ness connector backward to 90°? between G sensor and ABSCM&H/U. Or replace G sen- sor.
