Scribd
Upload
5 views2 pages

MP ct1

Uploaded by

nithya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
5 views2 pages

MP ct1

Uploaded by

nithya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

SRM INSTITUTE OF SCIENCE & TECHNOLOGY c) serial input port d) parallel output port

RAMAPURAM CAMPUS
DEPARTMENT OF ELECTRICAL AND ELECTRONICS 8. Port C of 8255 can function independently as
ENGINEERING a) input port b) output port
CYCLE TEST -I Date : c) either input or output ports d) both input and output ports
Sub. Code :15EE305J Max. Marks : 50
Sub. Name : Duration : 90 MIN 9. In 8257 (DMA), each of the four channels has
MICROCONTROLLERS a) a pair of two 8-bit registers b) a pair of two 16-bit registers
Year / SEM : III/ VI
c) one 16-bit register d) one 8-bit register
PART A (10 x 1 = 10 Marks) 10. The pin that disables all the DMA channels by clearing the mode
1. To address a memory location out of N memory locations, the registers is
number of address lines required is a) MARK b) CLEAR c) RESET d) READY
a) log N (to the base 2) b) log N (to the base 10)
c) log N (to the base e) d) log (2N) (to the base e)
PART B
2. The advantage of dynamic RAM is
(ANSWER ANY 4) (4*4=16)
a) high packing density b) low cost
11. Differentiate Microprocessor & Microcontroller
c) less power consumption d) all of the mentioned
12. Explain the flag register of 8085
3. The process of refreshing the data in the RAM to reduce the
13. Draw and explain the Tristate logic of microprocessor.
possibility of data loss is known as
14. Write the control word of 8255
a) data cycle b) regain cycle
15. Explain DMA data transfer and the related signals.
c) retain cycle d) refresh cycle
PART C
4. A mask programmed ROM is
Answer All The Questions (2*12= 24 marks)
a)programmed at the time of fabrication
b) programmed by the user 16. Draw and Explain the architecture of 8085
c) erasable and programmable (OR)
d) erasable electrically 17. Explain the classification of memory in detail
5․ Which one of the following circuits transmits two messages
simultaneously in one direction 18. With a neat diagram explain in detail about programmable
a)Duplex b)Diplex c)Simplex d)Quadruplex Peripheral I/O ports of 8255.
6. Name the address pair which store the address of memory
OR
location
a) BC b)HL c) DE d)AB 19. Explain the 8257 DMA controller with a neat block diagram
7. Programmable peripheral input-output port is other name for
a) serial input-output port b) parallel input-output port

You might also like