Scribd
Upload
5 views4 pages

Open Ended Project g1

Open

Uploaded by

pesnew182727
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
5 views4 pages

Open Ended Project g1

Open

Uploaded by

pesnew182727
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 4
OPEN ENDED PROJECT REPORT SQUARE WAVE GENERATOR USING IC741 Aim: To construct a square wave generator using IC 741 This multivibrator works in same way as a comparator by comparing the two input voltages and giving the output signals regarding the input voltage values.When the circuit is switched ON the C1 starts charging through the Resistors R1 and R2.The Resistor R2 was a variable one and it was used to change the frequency range of the output signal.When the voltage across the Capacitor rises above the junction R3 and Ré the output switches to fully negative voltage.C11 will begin to discharge and charges in the opposite direction When the negative voltage across the C1 falls below that pin 3 the circuit switches back quickly to the fully positive output value thereby giving out the high signal. The above cycle repeats endlessly resulting in giving out a series of square wave pulses as output through the Pin 3.The value of capacitor should be around 1uf and this circuit is capable of giving out output signal of frequency of (1Hz-25Hz) Apparatus Requires SI.No: Apparatus Specification | Quantity 1 Op-amp um7at ‘no 2 Resistor 1Mohm Ano 3 Resistor 100k ohm — | tno 4 Resistor 47 k ohm 1no 5 Resistor 10k ohm 2nos 6 Capacitor tuf ‘1no z Bread Board 1no 8 Duel regulated power supply 1no 9 Dso 1no Output TL Implemented : Procedure: 1. Check the components. 2. Setup the circuit on the breadboard and check the connections. 3. Variable resistance is kept at minimum or maximum position 4. Switch on the power supply. 5. Slowly vary the pot resistance and observe the frequency variations in DSO Result: Constructed a square wave generator using IC 741 and observed the waveform at various frequency. Output Obtained:

You might also like