Scribd
Upload
33 views2 pages

D301686X012 - ControlWave Flow Measurement Applications Guide-83-84

Second part ControlWave Briston flow Computer

Uploaded by

Julian Ferreira
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
33 views2 pages

D301686X012 - ControlWave Flow Measurement Applications Guide-83-84

Second part ControlWave Briston flow Computer

Uploaded by

Julian Ferreira
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ControlWave Flow Measurement Applications Guide

4.8.4 Coriolis Measurement


The Coriolis Equation Configuration page lets you configure gas flow
measurement using a coriolis meter.

Figure 4-15. Coriolis Calculation page

Note: If you chose coriolis measurement by mistake, and need to choose


either differential measurement or linear measurement instead, you
can reset the equation type to undefined, so you can re-select it. To
do this, click the Reset Meter Run’s Measurement Type button
on the Meter Run Overview page. See Section 3.2.

Field Description
Coriolis Equation Select the meter run number for which you want to
Configuration for Run# configure coriolis measurement.

Inputs

Air Density Specify the density of air constant.

Spec. Gravity Shows the specific gravity of the gas.

Revised Oct-2014 Measurement Group Config Tab 4-51


ControlWave Flow Measurement Applications Guide

K Factor Units Select the engineering units for the coriolis meter.

K Factor Specify the correction factor (K) for the coriolis meter.
This information is available from the coriolis meter
data plate.

Frequency Input Shows the current frequency from the high speed
counter input connected to the coriolis meter.

Static Pressure Shows the static pressure of the flowing gas.

Temperature Shows the temperature of the flowing gas.

Outputs

Flow Shows the calculated flow rate.

Flow Units Shows the engineering units for the calculated flow
rate reading.

K Factor Used Shows the value of the K factor used in the calculation.

4-52 Measurement Group Config Tab Revised Oct-2014

You might also like