Eim-11-Law-Week-6 Q-2
Eim-11-Law-Week-6 Q-2
Eim-11-Law-Week-6 Q-2
Department of Education
N a t i o n a l C a pi t a l Re g i o n
Sc h o o l s D i v i s i o n O f f i c e o f La s Pi ñ a s C i t y
ACTIVITY 1
DIRECTIONS: Choose the letter of the best answer. Write the chosen letter on a
separate sheet of paper.
6. Which of the following is an electric current that reverses its direction many times
a second at regular intervals?
A. Alternating Current C. Circuit Breaker
B. Circuit D. Kilowatt-hour
7. What is a closed path in which electrons from a voltage or current source flow.
Circuits can be in series, parallel, or in any combination of the two?
A. Ampacity C. Fuse
B. Circuit D. Henry
LEARNING ACTIVITY WORKSHEETS
Grade 11 – Electrical Installation and Maintenance NC II
8. What automatic device used for stopping the flow of current in an electric
Circuit?
A. Circuit C. circuit breaker
B. Current D. Circuit overload
9. What electrical material is used where electric current can flow freely?
A. Ampere C. Conductor
B. Circuit D. Ground
10. What is an electric charge through a conductor that can be compared to the flow
of water in a pipe measured in amperes?
A. Ampacity C. Circuit
B. Ampere D. Current
ACTIVITY 2
DIRECTIONS: Draw line Diagram, Schematic Diagram and Actual Wiring Diagram
1. One bulb controlled by single pole single throw.
Line Diagram
Schematic Diagram
Q2- Week 6
MELC: Circuit one bulb controlled by surface or flush type single pole switch W6
_IAEI912EL-Ia-IIj1 TLE
2. Two Bulbs connected in series circuit controlled by single pole single throw
Line Diagram
Schematic Diagram
Q2- Week 6
MELC: Circuit one bulb controlled by surface or flush type single pole switch W6
_IAEI912EL-Ia-IIj1 TLE
Two bulbs connected in parallel circuit controlled individually by single pole single throw.
Schematic Diagram
Q2- Week 6
MELC: Circuit one bulb controlled by surface or flush type single pole switch W6
_IAEI912EL-Ia-IIj1 TLE