Scribd
Upload
28 views4 pages

Ship Console Calibration

ship console calibration

Uploaded by

Arnaud Npago
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
28 views4 pages

Ship Console Calibration

ship console calibration

Uploaded by

Arnaud Npago
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

How to calibrate the steer and throttle levers of

Left & Right


throttle lever

Since Ship Console is a type of


joystick, calibration should be
done before use.
steer

1. Check the steer, left & right throttle are in the idle detent position. Check all buttons are powered on.

Idle detent
position
check

Buttons power check

2.Plug USB of Ship console to your computer. 5. Run “Calibration Wizard” and click “Next” till you
3. Go to “Control panel” => “Game Controllers” and see “X Rotation”.
check Ship Console is recognized as an USB pad.
4. Click “Properties” => “Setting” => “Calibration”.

Tel : +82-31-284-7090~91 Fax : +82-31-284-7092


www.vrinsight.com E-mail : [email protected] Web site : www.vrinsight.com
6. Move the steer to the left maximum. And to the right
Maximum.
(The steer movement is recognized as X Rotation)

7. Click “Next” till you see “Rudder”.


(The left throttle lever is recognized as Rudder)

8. Move the left throttle lever to the forward


maximum. And to the backward maximum.

9. Click “Next” till you see “Throttle”


(The right throttle lever is recognized as Throttle)

10. Move the right throttle lever to the forward


maximum. And to the backward maximum.
11. Click next and finish the calibration wizard.
.

Tel : +82-31-284-7090~91 Fax : +82-31-284-7092


www.vrinsight.com E-mail : [email protected] Web site : www.vrinsight.com
Controls setting (With Ship Simulator 2008)
1. Run Ship Simulator 2008.
2. Check the steer, left & right throttle are in the idle detent position. Check all buttons are powered on
3. Go to “Options” => Controls

4. Change the assigned input of Ship Controls. 4-2. When you see the below message, check the
(Example with Engine 1) left throttle for Engine 1 is in the idle detent position.
4-1. Place your cursor on the “Actions menu” and
double click it.

4-3. Move the left throttle to the forward maximum and wait till you see the below message.

Tel : +82-31-284-7090~91 Fax : +82-31-284-7092


www.vrinsight.com E-mail : [email protected] Web site : www.vrinsight.com
4.4. Move the left throttle to the backward maximum and wait till you see the below message.

5. Refer to the STEP No. 4 and change the assigned input for Ship Console : Interface, Ship controls and
Crane controls.

Tel : +82-31-284-7090~91 Fax : +82-31-284-7092


www.vrinsight.com E-mail : [email protected] Web site : www.vrinsight.com

You might also like