Scribd
Upload
19 views3 pages

Unit - 4 Programs With Raspberry Pi

Internet of things

Uploaded by

Tamizharasi A
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
19 views3 pages

Unit - 4 Programs With Raspberry Pi

Internet of things

Uploaded by

Tamizharasi A
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Python program for blinking LED

import RPi.GPIO as GPIO # Import Raspberry Pi GPIO library

from time import sleep # Import the sleep function from the
time module

GPIO.setwarnings(False) # Ignore warning for now

GPIO.setmode(GPIO.BOARD) # Use physical pin numbering

GPIO.setup(8, GPIO.OUT, initial=GPIO.LOW) # Set pin 8 to be


an output pin and set initial value to low (off)

while True: # Run forever

GPIO.output(8, GPIO.HIGH) # Turn on

sleep(1) # Sleep for 1 second

GPIO.output(8, GPIO.LOW) # Turn off

sleep(1) # Sleep for 1 second


Program:

Sensing temperature and humidity using DHT 11 sensor using


Raspberry Pi 4
import time
import board
import adafruit_dht
dhtDevice = adafruit_dht.DHT11(board.D17)
while True:
try: # Print the values to the serial port
temperature_c = dhtDevice.temperature
temperature_f = temperature_c * (9 / 5) + 32
humidity = dhtDevice.humidity
print(“Temp: {:.1f} F / {:.1f} C Humidity: {}% “.format(temperature_f, temperature_c,
humidity))
except RuntimeError as error:
# Errors happen fairly often, DHT’s are hard to read, just keep going
print(error.args[0])
time.sleep(2.0)
continue
except Exception as error:
dhtDevice.exit()
raise error
time.sleep(2.0)

You might also like