Scribd
Upload
377 views5 pages

Chapter 5. Suggested Problems

Design 1

Uploaded by

mohammedbsaiso
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
377 views5 pages

Chapter 5. Suggested Problems

Design 1

Uploaded by

mohammedbsaiso
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

PROBLEMS Page 276 - 11th Edition

PROBLEM 1. Prob. 5.1

A ductile hot-rolled steel bar has a minimum yield strength in tension and compression
of 350 MPa. Using the distortion-energy and maximum-shear-stress theories determine
the factors of safety for the following plane stress states:
(a) σx = 100 MPa, σy = 100 MPa
(b) σx = 100 MPa, σy = 50 MPa
(c) σx = 100 MPa, τxy = –75 MPa
(d) σx = –50 MPa, σy = –75 MPa, τxy = –50 MPa
(e) σx = 100 MPa, σy = 20 MPa, τxy = –20 MPa

PROBLEM 2. Prob. 5.36 Page 278


This problem illustrates that the factor of safety for a machine
element depends on the particular point selected for analysis.
Here you are to compute factors of safety, based upon the
distortion-energy theory, for stress elements at A and B of the
member shown in the figure. This bar is made of AISI 1006
cold-drawn steel and is loaded by the forces F = 0.55 kN, P =
4.0 kN, and T = 25 N ∙ m.
PROBLEM 3. Prob. 5.48 Page 280
A 25.400 mm, constant diameter shaft, is loaded with forces
at A and B as shown, with ground reaction forces at O and C. The
shaft also transmits a torque of 169.500 N · m throughout the
length of the shaft. The shaft has a tensile yield strength of
344.750 MPa. Determine the minimum static factor of safety
using:
(a) the maximum-shear-stress failure theory.
(b) the distortion-energy failure theory.

PROBLEM 4. Prob. 5.76


The figure shows a shaft mounted in bearings at A and D and
having pulleys at B and C. The forces shown acting on the pulley
surfaces represent the belt tensions. The shaft is to be made of AISI
1035 CD steel. Using a conservative failure theory with a design
factor of 2, determine the minimum shaft diameter to avoid
yielding.

225. 00-mm

You might also like