Scribd Logo
Upload

Welcome to Scribd!

  • 12 views

    Type Approval - GT3000 O2

    Uploaded by

    Hel Suarez
    certificate

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Type Approval - GT3000 O2

    Uploaded by

    Hel Suarez
    12 views3 pages
    certificate

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    certificate

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    12 views3 pages

    Type Approval - GT3000 O2

    Uploaded by

    Hel Suarez
    certificate

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 3

    <0>

    DET NORSKE VERITAS


    TYPE APPROVAL CERTIFICATE

    CERTIFICATE NO. A-12357

    This is to certify that the


    Gas Detector

    with type designation(s)


    GT3000-O2

    Manufactured by
    Detector Electronics Corporation (Det-Tronics®)
    MINNEAPOLIS MN, United States

    is found to comply with


    Det Norske Veritas' Rules for Classification of Ships, High Speed & Light Craft and Det Norske Veritas' Offshore Standards

    Application
    Location classes:

    Temperature D
    Humidity B
    Vibration B
    EMC B
    Enclosure C

    Høvik, 2011-06-29 This Certificate is valid until


    for Det Norske Veritas AS 2015-06-30

    Odd Magne Nesvåg DNV local office: Kjell Myhrsveen


    Head of Section New York Surveyor

    This Certificate is subject to terms and conditions overleaf. Any significant change in design or construction may render this Certificate invalid.
    The validity date relates to the Type Approval Certificate and not to the approval of equipment/systems installed.
    If any person suffers loss or damage which is proved to have been caused by any negligent act or omission of Det Norske Veritas, then Det Norske Veritas shall pay compensation to such
    person for his proved direct loss or damage. However, the compensation shall not exceed an amount equal to ten times the fee charged for the service in question, provided that the maximum
    compensation shall never exceed USD 2 million. In this provision "Det Norske Veritas" shall mean the Foundation Det Norske Veritas as well as all its subsidiaries, directors, officers,
    employees, agents and any other acting on behalf of Det Norske Veritas.

    DET NORSKE VERITAS AS, Veritasveien 1, NO-1322 Høvik, Norway, Tel.: +47 67 57 99 00, Fax: +47 67 57 99 11, Org.No. NO 945 748 931 MVA www.dnv.com
    Form No.: TA 1411a Issue: October 2009 Page 1 of 3
    Certificate No.: A-12357
    File No.: 473.30
    Job Id.: 262.1-010863-1

    Product description
    The GT3000-O2 gas detector is an intelligent industrial gas detector with electrochemical sensing element that provides
    continuous monitoring of the atmosphere for oxygen depletion with range 0-25% for oxygen depletion (< 21 %,V/V).
    Electrochemical sensing element provides improved accuracy and stability compared to solid-state sensors.
    Consists of a replaceable sensor module (model GTS) connected to a transmitter module (model GTX) with 4-20 mA output
    with HART protocol. Can be installed as a stand-alone device. Alternatively, the sensor/transmitter can be combined with a local
    or remote display, such as Det-Tronics FlexVu® UD10 and Autronica AutroVu AV10 universal display, Det-Tronics STB
    Termination Box or Autronica BN-342/EX Interface Unit.

    Application/Limitation
    This Type Approval Certificate covers GT3000-O2 gas detector (sensor and transmitter).
    When the hardware is used in applications to be classed by DNV, documentation for the actual application is to be submitted for
    approval by the manufacturer of the application system in each case. Reference is made to DNV Rules for Ships Pt.4 Ch.9
    Control and Monitoring Systems.

    Test results of the “Compass safe distance”:

    Equipment Compass; standard Compass; steering / standby steering / emergency


    GT3000-O2 45 cm 30 cm

    Ex installations to be approved in each case according to the Rules and Ex-Certification/ Special Condition for Safe Use listed in
    valid Ex-certificate issued by a notified/recognized Certification Body.

    Ex-certification is not covered by this certificate and the following paragraph, which is for information only, is based on
    information received from the manufacturer, but not verified by DNV.

    Information on Ex-Certification received from manufacturer – Not verified by DNV


    Equipment Certified Certificate No.
    GT3000-O2 Ex d mb [ia Ga] IIC T4 Gb IP66 FM10ATEX0009X

    Type Examination documentation

    Tests carried out


    Environmental/EMC:
    EN 60945:2002 (EMC part)
    IEC 60092-504:2001
    IEC 60533:1999
    Performance:
    EN 50104:2002/AMD2004
    For the bridge mounted components the ‘Acoustic noise and signals’ and the ‘Compass safe distance’ were measured
    th
    according to sections 11.1 and 11.2 of IEC 60945, 4 edition (2002).

    DET NORSKE VERITAS AS, Veritasveien 1, NO-1322 Høvik, Norway, Tel.: +47 67 57 99 00, Fax: +47 67 57 99 11, Org.No. NO 945 748 931 MVA www.dnv.com
    Form No.: TA 1411a Issue: October 2009 Page 2 of 3
    Certificate No.: A-12357
    File No.: 473.30
    Job Id.: 262.1-010863-1

    Marking of product
    GT3000-O2 consists of two sub parts, a transmitter and a sensor. These two sub parts will be marked as shown in table below:

    Type designation Sub parts of GT3000-O2 Sub parts designation Note


    GTXSM26YZ Y = A, B, C, E, T, R or W
    GTX (Transmitter)
    GT3000-O2 GTXSN26YZ Z = 4 or 5
    GTS (Sensor) GTSO225VD

    Product marking of enclosures as Display Unit, Sensor Termination Box and EX Interface Unit will be as follows:

    Type designation Type designation


    Note
    (Det-Tronics model - FlexVu) (Autronica model - AutroVu)
    UD10A5M25Y2 AV10A5M25Y2
    Display Unit
    UD10S5M25Y2 AV10S5M25Y2
    Y = A, B, C, E, T, R or W
    UD10A5N25Y2 AV10A5N25Y2
    UD10S5N25Y2 AV10S5N25Y2
    Type designation -
    Note
    (Det-Tronics model)
    Sensor Termination Box
    STB7AXY - X = 2M, 2N, 5Y or 5N
    STB7SXY - Y = A, B, C, E, T, R or W
    Type designation
    - Note
    EX Interface Unit (Autronica model)
    - BN-342/EX -

    Certificate retention survey


    The scope of the retention/renewal survey is to verify that the conditions stipulated for the type are complied with, and that no
    alterations are made to the product design or choice of systems, software versions, components and/or materials.
    The main elements of the survey are:
    • Ensure that type approved documentation is available
    • Inspection of factory samples, selected at random from the production line (where practicable)
    • Review of production and inspection routines, including test records from product sample tests and control routines
    • Ensuring that systems, software versions, components and/or materials used comply with type approved documents and/or
    referenced system, software, component and material specifications
    • Review of possible changes in design of systems, software versions, components, materials and/or performance, and make
    sure that such changes do not affect the type approval given
    • Ensuring traceability between manufacturer’s product type marking and the type approval certificate
    Retention survey is to be performed at least every second year and at renewal of this certificate.

    END OF CERTIFICATE

    DET NORSKE VERITAS AS, Veritasveien 1, NO-1322 Høvik, Norway, Tel.: +47 67 57 99 00, Fax: +47 67 57 99 11, Org.No. NO 945 748 931 MVA www.dnv.com
    Form No.: TA 1411a Issue: October 2009 Page 3 of 3

    You might also like