Scribd Logo
Upload

Welcome to Scribd!

  • 2 views

    Espace V 4-Control Štelovanje Zadnjeg Trapa

    Uploaded by

    Marko Marjanovic

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Espace V 4-Control Štelovanje Zadnjeg Trapa

    Uploaded by

    Marko Marjanovic
    2 views4 pages

    Original Title

    Espace V 4-control štelovanje zadnjeg trapa

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    2 views4 pages

    Espace V 4-Control Štelovanje Zadnjeg Trapa

    Uploaded by

    Marko Marjanovic

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 4

    REARAXLEASSEMBLY:ADJUSTMENT

    Note, one or more warnings are present in this procedure

    Note:

    Throughout the axle assembly checking and adjustment process:


    the Renault Card must remain in the reader,
    do not press the START button.

    ADJUSTMENT

    1. ADJUSTMENT PREPARATION OPERATION

    Check the geometry of the axle assembliesFront and rear axles : Check .

    2. REAR AXLE ADJUSTMENT

    1- CAMBER ADJUSTMENT
    Undo the stub axle carrier upper nut(1 ) .

    Adjust the camber angle using the eccentric bolt (2 ) according to the values measured at the time of
    the check.

    Torque tighten the upper nut of the stub axle carrier while holding the eccentric 190 N.m .

    Check the camber values.

    2- ADJUSTMENT OF THE WHEEL ALIGNMENT


    Loosen the nut(3 ) of the steering con rod.

    Adjust the wheel alignment using the eccentric bolt (4 ) according to the values measured at the time of
    the check.

    Torque tighten the nut of the steering con rod while holding the eccentric 90 N.m.

    Check the wheel alignment values.


    FINALOPERATION

    Calibrate the steering wheel angle sensor.

    Apply the after repair procedure:


    connect the diagnostic tool,
    select "Braking computer",
    go to repair mode,
    display the "Before/after repair procedure" for the computer selected,
    select "Steering wheel angle sensor" in the "List of components controlled by this computer" section,
    carry out the operations described in the "After repair procedure" section.

    Apply the after repair procedure:


    connect the diagnostic tool,
    select "4WS computer",
    go to repair mode,
    display the "Before/after repair procedure" for the computer selected,
    select "4WS actuator" in the "List of components controlled by this computer" section,
    carry out the operations described in the "After repair procedure" section.

    Repair-13x02x05-01x67-1-9-1.xml

    XSL version : 3.02 du 22/07/11

    You might also like