Scribd
Upload
35 views4 pages

Workshop 6 - PCB Design - LayoutDesign

Uploaded by

HAZIQ FIRDAUS
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
35 views4 pages

Workshop 6 - PCB Design - LayoutDesign

Uploaded by

HAZIQ FIRDAUS
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

UNIVERSITI TEKNIKAL MALAYSIA MELAKA

UNIVERSITI
FAKULTI TEKNIKAL MALAYSIA
KEJURUTERAAN MELAKA
ELEKTRONIK DAN
KEJURUTERAAN KOMPUTER
FAKULTI TEKNOLOGI DAN KEJURUTERAAN
ELEKTRONIK DAN KOMPUTER

DERN 1312
PCB DESIGN AND FABRICATION WORKSHOP
DENE 1221
ENGINEERING WORKSHOP 2

WORKSHOP 5

PCB DESIGN - LAYOUT DESIGN

LAB SESSION 1

PCB DESIGN USING PROTEUS


PART 1: SCHEMATIC DESIGN AND CIRCUIT S

Prepared by:

Industrial Electronic Department, FKEKK


Semester 3 2023/2024
OBJECTIVE:
1. Design PCB layout.
2. Practice the right techniques in handling materials, tools and equipments during
PCB design.

COMPONENTS / EQUIPMENTS:
NO COMPONENTS NUMBER QUANTITY
1. IC Timer 555 IC - 2 1
2. IC CMOS 4017 IC - 1 1
3. IC Socket 8 Ways - 1
4. IC Socket 16 Ways - 1
5. Resistor 4.7 Ω R1 & R2 2
6. Resistor 1 kΩ R3 & R4 2
7. Resistor 390 kΩ R5 1
8. Variable Resistor 500 kΩ to 2 MΩ VR1 1
9. LED Blue (or any color) 5mm L0 – L3 4
10. LED Orange (or any color) 5mm L4 – L7 4
11. Electrolytic Capacitor 10 µF, 25 V C2 1
12. Capacitor ceramic 10 nF C1 1
13. PCB Board 7.5 x 7.5 cm 1
14. Proteus Software 8.10

THEORY:
The PCB design process combines component placement and routing to define
electrical connectivity on a manufactured circuit board. This is the list of basic of PCB
layout and design steps:
• Create the Schematic
• Create and Setup a PCB
• Link the Schematic to the PCB
• Define the Board Size and Layer Stack
• Place Components
• Route Traces
• Verify Circuit Board Layout
• Add Labels and Identifiers

PROCEDURE:
1. Use schematic circuit as shown in Figure 1 in workshop 4.
2. Design a layout and route all the connections manually following the PCB
design guidelines. Use a single layer board.
3. Save and record all results.

Figure 1: Schematic circuit of Running Light LED

RESULT.

DISCUSSION.
CONCLUSION.

WORKSHOP 4 - RUBRIC

NOVICE APPRENTICE PROFICIENT EXEMPLARY


CRITERIA ACTIVITIES PERCENTAGE
(1) (2) (3) (4)
Wiring 0.5%

Component
0.5%
Placement
Schematic
Labelling 0.5%

Simulation 1.5%

Routing 2.0%

Component
Layout 2.0%
Placement
Labelling 1.0%

Images 0.5%
Report
Discussion 1.5%

You might also like