SL-206 odometer instruction
Meter Function
power on/ off, shifting, light on, battery level, percentage of battery level, trip distance, total
distance, running time, gear indicator , cruise mode, unit change
Button instruction
This meter sets 3 buttons:
1. Button M: (functional button) long press 3 seconds to power on/ off
Short press to show trip distance/ total distance/ running time
2. Button + : Long press 3 seconds to light on/ off
Short press to shift
Long press with button “ - “ together to enter setting page
3. Button - : Short press to shift
Long press with button “+ “ together to enter setting page
Display instruction
1. Percentage of battery level
2. Battery level
3. Light on indicator
4. Speed indicator
5. Speed unit (kilometer or mile)
6. Cruise mode
7. Gear indicator
8. Trip, total distance, time mode change
9. Trip , total distance, time indicator
10. Distance unit
11. Brake indicator
12. Motor malfunction indicator
13. Throttle malfunction indicator
14. Controller malfunction indicator
Setting instruction
Long press button “+ “ and “ - “ together to enter setting page P0
1. Factory reset : Enter into P0 page, 30 seconds long press button ”+”, meter data wipe, back to
original factory data
2. Speed unit change : Enter into P0 page, press button “M” to P1 page, then press button “+ “ or
“ - “ to choose “0” or “1” , “0” is kilometer, “1” is mile, after setting, press button “+” and “-”
together to back, or automatically back after 15 seconds
3. Speed change : Enter into P0 page, press button “M” to P2 page ( need adjust when showing
wrong wheel size, speed indicator do not match with actual speed ), press button”+” or “- “ ,
change the data, default data is 35. Press “+” or “- “ to change the data from 5~99, the bigger the
data, the faster the speed indicator. After setting, press button “+” and “-” together to back, or
automatically back after 15 seconds
NOTE: For BLAUPUNKT ebike, 14inch bike (T3) default P2 , R-13.2 ; 16inch (T4,S6) default
P2, R-15.6 ; 20inch (T6, S6L) default P2, R-19.7
P3 , to set throttle icon on display, if bike w/o, need set with P3 to remove the throttle icon
P4, to set the assit rate
P3 and P4 are factory settings, we operate here in our factory before parts or bikes ship out, so please do
not resetting P5 is choosing voltage , 36V or 48V
