Scribd
Upload
820 views1 page

Sae 1010

Uploaded by

Sonu Maurya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
820 views1 page

Sae 1010

Uploaded by

Sonu Maurya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Material - SAE 1010

Standard Specification For Carbon Steel Compositions For Forging To Hot-Rolled And Cold-
Finished Sheets and Tubing
Group - Ferrous Mild Steel Alloys
Sub Group - SAE 1010 Carbon Steel Compositions For Forging To Hot-Rolled And Cold-Finished Sheets and Tubing
Application - Intended for Valve, Pump, General Engineering, Automotive and Other Industries
Grade Belongs to the Industry - Sheet and Tubing

Chemical Composition Heat Treatment


Carbon C% 0.150 max.
Manganese Mn % 0.300 - 0.600
Phosphorus P% 0.040 max.
As Raw or Annealing or Normalizing or Hardening and
Sulphur S% 0.050 max.
Tempering
Iron Fe % Balance
- - -
- - -
- - -
- - - Mechanical Properties
- - - Tensile Strength in Mpa 320 - 653.3
- - - Yield Strength in Mpa 180 min.
- - - Elongation in % 20 min.
- - - Reduction of Area in % 40 - 50
- - - Hardness in HB 95 - 105
- - - Impact in Joule -

Cross Reference Table


Material Standard Country Grade Belong to the Industry
G10100 UNS USA Bars, Wire Rods, Plates, Strip, Sheets and Tubing
1010 AISI USA Tubing
A 1040 1010 ASTM USA Bars, Wire Rods, Plates, Strip, Sheets and Tubing
A 108 Grade 1010 ASTM USA Bar and Sheet
A 29 1010 ASTM USA Bar
A 29 M1010 ASTM USA Bar
A 510 1010 ASTM USA Bars, Wire Rods, Plates, Strip, Sheets and Tubing

Further any inquiry to discuss with Gravity Cast Pvt. Ltd. – Gravity Group of Companies team member Call
on +918469160029, or email [email protected]

All information in our data sheets and website is indicative only and is not intended to be a substitute for the full specification from which it is extracted. It is intended to
provide typical values to allow comparison between metal alloy option rather than a definitive statement of mechanical performance or suitability for a particular
application as these will vary with temperature, product type and product application. It is presented apart from contractual obligations and does not constitute any
guarantee of properties or of processing or application possibilities in individual cases. Our warranties and liabilities are stated exclusively in our terms of business.

ONE STOP SOLUTION FOR METAL PARTS

You might also like