KLEIBERIT 706.0.
05
Reactive hotmelt based on Application techniques
polyurethane (PUR) for surface For surface lamination, KLEIBERIT 706.0.05 is
processed with melting equipment (suitable for
lamination
PUR hotmelt adhesives) on a roller coater
application unit.
Fields of application
Surface lamination
Reference value for open time for application onto
Good adhesion to various materials, such as chip boards: up to 1-3 minutes
polystyrene, wood, plaster, woven material, for
wood material, PVC, aluminium and metal Application quantity: 100 g/m²
plate (dependant upon the material used, pre- Application temperature: 120°C
treatment could be necessary) Room temperature: from 20°C
The long open time allows large surfaces areas
to be bonded Chemical cross linking of PUR hotmelt requires
moisture. Therefore sufficient air humidity has to be
present during processing.
Advantages
Following cross-linking, a highly heat resistant,
watertight, extremely cold resistant and durable Application devices
bond is attained Tank device with a nitrogen blanket
Low processing temperature Barrel melting plant for 20 litre containers
Long open time Suitable roller application system
Properties of the adhesive Cleaning
Base: polyurethane Following completion of the work with KLEIBERIT
Specific weight: approx. 1.1 g/cm³ 706.0.05, either run the application empty or drain
Viscosity (on the day of production) off the remaining contents. Immediately afterwards
Brookfield HBTD 10 rpm: apply melted KLEIBERIT Cleaning Agent 761.8
at 120°C 12,000 ± 3,000 mPa s
and reverse the direction of the rollers until the last
at 140°C 6,000 ± 2,000 mPa s
traces of PUR Hotmelt have been removed.
Identification: see our safety data sheet Hotmelt adhesive which has already cross-linked
can only be removed mechanically.
Attention
When hotmelt adhesives are melted and applied,
vapours are set free and an unpleasant odour can
occur, even if the recommended working
temperature has been observed. Moreover if the
prescribed working temperature is exceeded over a
longer period, harmful decomposition products can
develop. Precautions should be taken to eliminate
the vapours, e.g. by using a suitable ventilation
system.
Restricted to professional users Page 1 of 2
KLEIBERIT 706.0.05
Packaging
KLEIBERIT 706.0.05:
aluminum bag in fiber drum, 1.80 kg net
aluminum bag in fiber drum, 20.0 kg net
metal drum, 50 kg net
metal drum, 190 kg net
KLEIBERIT Cleaning Agent 761.8:
plastic pail, 20.0 kg net
fiber drum, 136.0 kg net
Additional packaging sizes available upon request.
Storage
KLEIBERIT 706.0.05 can be stored in factory
sealed containers approx. 12 months
Protect from humidity!
Version 24.11.2021 lz; replaces previous versions
Adhesive and Waste Disposal Service
Our application department may be consulted at any time without obligation. The
Waste Code 080409 statements made herein are based on our experience gained to date. They are to be
considered as information without obligation. Please test and establish for yourself
Our containers are made of recyclable material. Well drained containers can be the suitability of our products for your particular purposes. No liability exceeding the
recycled. value of our product can be derived from the foregoing statements. This also applies
to the technical consultancy service which is rendered free of charge and without
obligation.
Restricted to professional users Page 2 of 2
