RHHTT-65A-R4-V2
10-port sector antenna, 2x 694–960, 4x 1695–2180 and 4x 2490-2690
MHz, 65° HPBW, 4x RET. High bands (H1/H2) arrays are diplexed at the
element level.
Independent tilt for 694-960 and 1695-2180 MHz arrays. Shared tilt for the two 2490-2690 MHz
arrays
General Specifications
Antenna Type Sector
Band Multiband
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN
Radome Material Fiberglass, UV resistant
Radiator Material Aluminum | Low loss circuit board
Reflector Material Aluminum
RF Connector Interface 4.3-10 Female
RF Connector Location Bottom
RF Connector Quantity, high band 8
RF Connector Quantity, low band 2
RF Connector Quantity, total 10
Remote Electrical Tilt (RET) Information
RET Hardware CommRET v2
RET Interface 8-pin DIN Female | 8-pin DIN Male
RET Interface, quantity 1 female | 1 male
Input Voltage 10–30 Vdc
Internal RET High band (3) | Low band (1)
Power Consumption, idle state, maximum 2W
Power Consumption, normal conditions, maximum 10 W
Protocol 3GPP/AISG 2.0
Page 1 of 6
©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
RHHTT-65A-R4-V2
Dimensions
Width 350 mm | 13.78 in
Depth 208 mm | 8.189 in
Length 1400 mm | 55.118 in
Net Weight, without mounting kit 20.3 kg | 44.754 lb
Array Layout
Port Configuration
Electrical Specifications
Impedance 50 ohm
Page 2 of 6
©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
RHHTT-65A-R4-V2
Operating Frequency Band 1695 – 2180 MHz | 2490 – 2690 MHz | 694 – 960 MHz
Polarization ±45°
Total Input Power, maximum 1,000 W @ 50 °C
Electrical Specifications
Frequency Band, MHz 694–862 880–960 1695–1920 1920–2180 2490–2690
Gain, dBi 14.2 14.7 17.1 17.4 17.6
Beamwidth, Horizontal, 68 63 61 61 65
degrees
Beamwidth, Vertical, degrees 16.2 14.1 7.4 6.8 5.6
Beam Tilt, degrees 3–18 3–18 3–13 3–13 3–13
USLS (First Lobe), dB 18 19 19 21 14
Front-to-Back Ratio at 180°, 32 32 31 36 38
dB
Isolation, Cross Polarization, 25 25 25 25 25
dB
Isolation, Inter-band, dB 30 30 30 30 30
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150
Input Power per Port at 50°C, 300 300 250 250 200
maximum, watts
Electrical Specifications, BASTA
Frequency Band, MHz 694–862 880–960 1695–1920 1920–2180 2490–2690
Gain by all Beam Tilts, 13.9 14.4 16.8 17.1 16.9
average, dBi
Gain by all Beam Tilts ±0.5 ±0.5 ±0.5 ±0.3 ±0.9
Tolerance, dB
Gain by Beam Tilt, average, 3 ° | 14.0 3 ° | 14.7 3 ° | 16.8 3 ° | 17.1 3 ° | 16.8
dBi 10 ° | 14.0 10 ° | 14.5 8 ° | 16.9 8 ° | 17.3 8 ° | 17.1
18 ° | 13.7 18 ° | 14.0 13 ° | 16.5 13 ° | 16.9 13 ° | 16.4
Beamwidth, Horizontal ±2.4 ±2.5 ±3.8 ±2.2 ±2.2
Tolerance, degrees
Beamwidth, Vertical ±1.4 ±0.9 ±0.4 ±0.5 ±0.4
Tolerance, degrees
USLS, beampeak to 20° above 18 19 12 14 13
beampeak, dB
Front-to-Back Total Power at 25 23 27 26 28
180° ± 30°, dB
20 21 20 20 19 Page 3 of 6
©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
RHHTT-65A-R4-V2
CPR at Boresight, dB 20 21 20 20 19
CPR at Sector, dB 10 9 10 9 9
Mechanical Specifications
Wind Loading @ Velocity, frontal 221.0 N @ 150 km/h (49.7 lbf @ 150 km/h)
Wind Loading @ Velocity, lateral 185.0 N @ 150 km/h (41.6 lbf @ 150 km/h)
Wind Loading @ Velocity, maximum 469.0 N @ 150 km/h (105.4 lbf @ 150 km/h)
Wind Loading @ Velocity, rear 234.0 N @ 150 km/h (52.6 lbf @ 150 km/h)
Wind Speed, maximum 241 km/h (150 mph)
Packaging and Weights
Width, packed 448 mm | 17.638 in
Depth, packed 355 mm | 13.976 in
Length, packed 1544 mm | 60.787 in
Weight, gross 33.9 kg | 74.737 lb
Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
UK-ROHS Compliant
Included Products
BSAMNT-3 – Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members.
Kit contains one scissor top bracket set and one bottom bracket set.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 4 of 6
©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
BSAMNT-3
Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm)
OD round members. Kit contains one scissor top bracket set and one
bottom bracket set.
Product Classification
Product Type Downtilt mounting kit
General Specifications
Application Outdoor
Color Silver
Dimensions
Compatible Diameter, maximum 115 mm | 4.528 in
Compatible Diameter, minimum 60 mm | 2.362 in
Weight, net 6.2 kg | 13.669 lb
Material Specifications
Material Type Galvanized steel
Packaging and Weights
Included Brackets | Hardware
Packaging quantity 1
Weight, gross 6.4 kg | 14.11 lb
Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
UK-ROHS Compliant
Page 5 of 6
©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
BSAMNT-3
Page 6 of 6
©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
