Quarterly Exam in Tle 9

Republic of the Philippines
Department of Education
REGION XIII-Caraga
TANDAG CITY DIVISION
MABUHAY INTEGRATED SCHOOL
P-Nangka, Brgy. Mabuhay, City of Tandag, Surigao del Sur
4th QUARTERLY EXAM IN TECHNOLOGY AND LIVELIHOOD EDUCATION
Electrical Installation and Maintenance – Grade 9
Multiple Choice. Directions: Read the statement carefully and identify what is being described or
defined. Write the letter only.
1. A law in electricity that states the current in a circuit is equal to the potential difference divided by
the resistance of the circuit.
a. Ohms law b. voltage c. current d. Ampere
2. Used for cutting and holding fine wires. This can reach tight space or small opening where other
pliers cannot reach and also used in making terminal loops of copper wires.
a. Hammer b. Long Nose Pliers c. Flat Screw Driver d. Allen Screw Driver
3. Who discovered ohms law?
a. Simon ohms b. Georg Ohms c. Volta ohms d. Georg Simon Ohm
4. A unit of measure of electric current.
a. Ampere b. circuit c. multi tester d. Resistance
5. The path of electric current from the source to the components and goes back to the source.
a. conductor b. Circuit c. kilowatt d. Ampere
6. A wire or a cord which provides path for current flow.
a. Circuit b. Ampere c. Kilowatt d. Conductor
7. A wire through which current flows.
a. Ampere b. kilowatt c. hot wire d. conductor
8. It is used by linemen to remove insulation of wire and cables in low and high voltage transmission
lines.
a. Hacksaw b. Electrician’s Knife c. Long Nose Pliers d. Philips Screw Driver
9. It is a device inserted to a convenience outlet to conduct electric current. A flat cord is attached to
it on one end and the other end is connected to a current consuming instrument or appliance.
a. Fuse b. Switch c. Male Plug d. Lamp Holders
10. This is a circuit protective device that automatically blows and cut the current when an overload
or short circuit happens.
11. This is a rectangular shaped metallic or plastic (PVC) material in which flush type convenience
outlet and switched are attached.
a. Clamps b. Conduits c. Flat Cord d. Utility Box
12. They are electrical materials used as the passage of wires for protection and insulation.
13. They are used to attach metallic or non-metallic conduit to the junction or utility boxes.
a. Clamps b. Conduits c. Connectors d. Junction Box
14. This is a protective device used to automatically cut off the current when trouble in the circuit
such as short circuit or overload occurs.
a. Clamps b. Connectors c. Junction Box d. Circuit Breaker
15. It is an octagonal shaped electrical material where the connections or joints of wires are being
done. It is also where the flush type lamp holder is attached.
a. Clamps b. Connectors c. Junction Box d. Circuit Breaker
16. A device that connects and disconnects the flow of electric current in a circuit.
17. It is a duplex stranded wire used for temporary wiring installation and commonly used in
extension cord assembly.
18. It is a device that acts as a convenient source of electrical energy for current consuming
appliances.
a. Connectors b. Junction Box c. Circuit Breaker d. Convenience Outlet
19. Devices that hold and protect the lamp and are also called as receptacles.
20. It is an electrical material used to hold and anchor electrical conduits in its proper position.
21. An instrument used to measure the amount of electrical current intensity in a circuit.
a. Ammeter b. Voltmeter c. Ohmmeter d. Micrometer
22. A pocket-sized tools used to test the line wire or circuit if there is current in it.
a. Ruler b. Test light c. Wire gauge d. Pull-push rule
23. A measuring tool used to measure the length of an object in centimeter and inches.
24. It is used to measure the diameter of wires/conductors in circular mils. It can measure small and
big sizes of wires and cables.
25. It is used to measure the voltage, resistance and current of a circuit. It is connected in parallel or
series with the circuit depending on what to measure.
a. Ammeter b. Voltmeter c. Ohmmeter d. Volt-Ohmmeter
26. An instrument used to determine the size of wires/conductors.
27. It is a measuring tool used to measure length, width and thickness of short flat object and in
sketching straight lines. a. Ruler b. Test light c. Wire gauge d. Pull-push
rule
28. It is an instrument used to measure the electrical pressure or voltage of a circuit.
29. It is also called tong-tester. It is used to measure current flowing in a conductor.
a. Ammeter b. Voltmeter c. Ohmmeter d. Clamp Ammeter
30. It is the process or the result of determining the ratio of a physical quantity such as length, time,
temperature, etc.
a. Measurement b. Extension Cord c. Requisition Slip Form d. Common Wire Splices
Identify the following electrical materials:
Junction box Utility box circuit breaker Receptacle single switch Long nose plier
Hammer Diagonal cutting plier Hacksaw stubby screwdriver
31. 33. 33. 35. 37.
36. 38.
32. 34.
39. 40.
41-50 compute the given data.
How many bulbs can be installed in a 20 ampere circuit if each bulb has wattage of 50
watts?
How many bulbs can be installed in a 20 ampere circuit if each bulb has wattage of 100
watts?

Quarterly Exam in Tle 9

Uploaded by

Copyright:

Available Formats

Quarterly Exam in Tle 9

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Quarterly Exam in Tle 9

Uploaded by

Copyright:

Available Formats

Republic of the Philippines

31. 33. 33. 35. 37.

41-50 compute the given data.

You might also like