Scribd
Upload
111 views2 pages

SOP For PH Meter

Uploaded by

anjumpq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
111 views2 pages

SOP For PH Meter

Uploaded by

anjumpq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

BIO CLASSIC PHARMA

Title: SOP for pH Meter

Department: Q.C Revision #:01 EffectiveDate:12-10-2023 Review Date: 12-10-2026


Doc. No.: BCP/SOP/03-002 Issued Date: 12-10-2023 Page 1 of 2

Title: STANDARD OPERATING PROCEDURE FOR INSTRUMENTS

TABLE OF CONTENTS

1. PURPOSE
2. SCOPE
3. RESPONSIBILITIES & AUTHORITIES
4. OPERATING INSTRUCTION
5. PRECAUTION
6. CLEANING AND MAINTAINANCE

AMENDMENT STATUS

Sr.# Date of Issue Page Page


Details of change / review
Amendment Status No Status
1

Prepared by Checked by Approved by

____________ ___________ ______________


QC Officer QC Manager QA Manager
BIO CLASSIC PHARMA
Title: SOP for pH Meter

Department: Q.C Revision #:01 EffectiveDate:12-10-2023 Review Date: 12-10-2026


Doc. No.: BCP/SOP/03-002 Issued Date: 12-10-2023 Page 2 of 2

1. Purpose:
It is established for the proper operation of pH meter.
2. Scope:
It is applicable in the testing in quality control department.
3. Responsibilities and Authorities:
Quality Control Manager
Quality Control Officer
Asst. Quality Control
4. Operating Instructions:
 Wash pH electrode with distilled water carefully and clean its external surface with tissue paper
 Dip this electrode in Buffer pH 4.00 and press CAL
 Allow the meter to read buffer and then again press CAL
 The device enter in calibration mode and show CAL 1
 The screen shows END to confirm the calibration process completed
 Again wash pH electrode with distilled water carefully and clean its external surface with tissue
paper
 Dip this electrode in Buffer pH 7.00 and press CAL
 The device enter in calibration mode and show CAL 2
 The screen shows END to confirm the calibration process completed
 Dip this electrode in Buffer pH 10.00 and press CAL
 The device enter in calibration mode and show CAL 3
 The screen shows END to confirm the calibration process completed
 Press ENTER to end two point calibration
 Again wash pH electrode with distilled water carefully and dip in the sample whose pH is to be
measured
 Stir gently with electrode and allow to stable
 Note the reading
 Wash pH electrode with distilled water carefully and place in 3M KCl solution.
5. Precautions:
 Avoid buffer contamination
 Protect electrodes from damage
6. Cleaning and maintenance:
Clean the external surface with dry clean dust.

Prepared by Checked by Approved by

____________ ___________ ______________


QC Officer QC Manager QA Manager

You might also like