Scribd Logo
Upload

Welcome to Scribd!

  • 8 views

    Instructions Cherries

    Uploaded by

    vivigarvasionigro

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Instructions Cherries

    Uploaded by

    vivigarvasionigro
    8 views6 pages

    Original Title

    Instructions_Cherries

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    8 views6 pages

    Instructions Cherries

    Uploaded by

    vivigarvasionigro

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 6

    thanks for your purchase of the

    CHERRIES MODEL
           
         
            
           (s
       ).    
                   

                


             
              
         

      


    about this model
         4 in. x 2 in. x 3.5 in.

     

    materials needed
    These are the material suggestions if you want to make the model as shown in the photo.
    You can use any material or color substitutions that you would like, as long as they are in the
    same quantities as the material that you are substituting.

    • Glue. Preferably the liquid kind. Hot glue, glue sticks, and adhesive tape either make a
    mess of your model or just don’t stick well enough to hold it together.
    • 1 sheet Red cardstock - 12” x 12”
    • 1 sheet Green cardstock - 12” x 12” or 8.5” x 11”
    • 1 sheet Brown cardstock - 12” x 12” or 8.5” x 11”

    fold lines & preparation


    This design may have both mountain and valley fold lines. This means that some lines will
    fold in and others will fold out depending on the design. You’ll need to watch the line
    pattern and be sure you are folding the paper in the right direction.

    Mountain Fold Line

    Valley Fold Line

    Mountain Fold Valley Fold


    piece identification guide
    Take a moment to identify and label the pieces of the model on the reverse side after they have been cut out. ( The Piece Identification Guide
    is only meant to be used as a reference for identifying pieces and should not be cut out.)

    Red
    R2 x6
    R1
    R3

    Green Brown

    B2 x2

    G1 G2 x2
    page 1

    1 2

    R2

    R1

    Bottom tab

    Before beginning assembly, make sure to identify, label, and fold all NOTE: The rounded tabs are there to identify the bottom of the
    your pieces. Start assembly by gluing one of the R2 pieces to R1 as cherry. This is just so you don’t accidentally glue the piece on upside
    shown. Then, continue gluing on all the rest of the R2 pieces. down.

    3 4

    This is how it should look once all the R2 pieces have been glued on. Glue R3 to the cherry starting with the bottom. (See Step 5 for more
    assembly tips.)

    5 6

    NOTE: You will probably need to insert a needle or hook tool into the Continue gluing R3 by moving up the side of the cherry one section at
    cherry to push the tabs in place from the inside of the model. a time. Again, use your needle or hook tool to press the tabs in place
    from the back. Gluing one section at a time allows you to make sure
    that you get a clean fit without getting overwhelmed.
    page 2

    7 8
    DO NOT GLUE TOP FLAP YET

    G2 G1 G2

    IMPORTANT: Do not glue the top flap yet. Glue the G1 piece between the two G2 pieces.

    9 10
    B2

    The pointed ends of the G2 pieces should point outward as shown. Next, glue a B2 piece to each side of the top of the stems.

    11 12

    Insert the pointed end of the stem through the slot in the top of the Glue the pointed tabs to the bottom side of the top flap as shown. You
    cherry. can now glue down the top flap.
    page 3

    13 14

    It should look like this. Repeat Steps 1 through 7 for the other cherry. Insert the other stem through the slot on the other cherry and glue
    the tabs as you did before.

    15

    Congratulations! You are finished.

    You might also like