Scribd
Upload
11 views

Patient Monitoring System Program

Uploaded by

TIRUPATHI Mounika
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
11 views

Patient Monitoring System Program

Uploaded by

TIRUPATHI Mounika
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 2

#include <LiquidCrystal.

h>
#include <TimerOne.h>
LiquidCrystal lcd(13, 12, 11, 10, 9, 8);

int val;
int tempPin = A0;// temperature Sensor Pin
int HBSensor = 4;// Sensor Pin
int HBCount = 0;
int HBCheck = 0;
int TimeinSec = 0;
int HBperMin = 0;
int HBStart = 2;
int HBStartCheck = 0;

void setup() {
// put your setup code here, to run once:
lcd.begin(20, 4);
pinMode(HBSensor, INPUT);
pinMode(HBStart, INPUT_PULLUP);
Timer1.initialize(800000);
Timer1.attachInterrupt( timerIsr );
lcd.clear();
lcd.setCursor(0,0);
lcd.print("Current HB : ");
lcd.setCursor(0,1);
lcd.print("Time in Sec : ");
lcd.setCursor(0,2);
lcd.print("HB per Min : 0.0");
lcd.setCursor(0,3);
lcd.print("Body Temp : ");

void loop() {

if(digitalRead(HBStart) == LOW){
//lcd.setCursor(0,3);
//lcd.print("HB Counting ..");
HBStartCheck = 1;}
if(HBStartCheck == 1)
{
if((digitalRead(HBSensor) == HIGH) && (HBCheck == 0))
{
HBCount = HBCount + 1;
HBCheck = 1;
lcd.setCursor(14,0);
lcd.print(HBCount);
lcd.print(" ");
}
if((digitalRead(HBSensor) == LOW) && (HBCheck == 1))
{
HBCheck = 0;
}
if(TimeinSec == 10)
{
HBperMin = HBCount * 6;
HBStartCheck = 0;
lcd.setCursor(14,2);
lcd.print(HBperMin);
lcd.print(" ");
//lcd.setCursor(0,3);
//lcd.print("Press Button again.");
HBCount = 0;
TimeinSec = 0;
}
}

val = analogRead(tempPin);
float mv = (val/1024.0)*5000;
float cel = mv/10;
lcd.setCursor(14,3);
lcd.print(cel);
lcd.print(" ");
delay(100);

void timerIsr()
{
if(HBStartCheck == 1)
{
TimeinSec = TimeinSec + 1;
lcd.setCursor(14,1);
lcd.print(TimeinSec);
lcd.print(" ");
}
}

You might also like