Scribd
Upload
17 views2 pages

CP211 - Tutorial 5

Tutorial 6 qn 2 x 5 6 x 1 84 to get a pimple on your way home or any other African American hair ya know I am fine with it is possible to get

Uploaded by

kyamaniderick
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17 views2 pages

CP211 - Tutorial 5

Tutorial 6 qn 2 x 5 6 x 1 84 to get a pimple on your way home or any other African American hair ya know I am fine with it is possible to get

Uploaded by

kyamaniderick
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

UNIVERSITY OF DAR ES SALAAM

Department of Chemical and Process Engineering


CP211: FLUID MECHANICS Tutorial 5

1. Show that the Volumetric flow rate through the venturi throat is given by
2P
A2C D
• 
V = A1u1 = A2u2 =
2
A 
1 −  2 
 A1 
2. Kerosene flows through the Venturi meter shown in Figure 1 with flow rates between
0.005 and 0.050 m3/s. Determine the range in pressure difference, p1 − p2, needed to
measure these flow rates.
3. Water flows through the pipe contraction shown in Figure 2. For the given 0.2-m
difference in the manometer level, determine the flow rate as a function of the diameter of
the small pipe, D.
4. The specific gravity of the manometer fluid shown in Figure 3 is 1.07. Determine the
volume flowrate, Q, if the flow is inviscid and incompressible and the flowing fluid is
(a) water, (b) gasoline (SG = 0.68), or (c) air at standard conditions (ρ = 1.23 kg/m3).
5. Air flows through the device shown in Figure 4. If the flow rate is large enough, the
pressure within the constriction will be low enough to draw the water up into the tube.
Determine the flow rate, Q, and the pressure needed at section (1) to draw the water into
section (2). Neglect compressibility and viscous effects.
6. What diameter orifice hole, d, is needed if under ideal conditions the flow rate through the
orifice meter of Figure 5 is to be 30 gal/min of seawater with p1 − p2 = 2.37 lb/in2? The
contraction coefficient is assumed to be 0.63. (1 gal = 231 in3)
7. Compute the ideal flow rate through the pipe system shown in Figure 6.
8. Water (assumed frictionless and incompressible) flows steadily from a large tank and exits
through a vertical, constant-diameter pipe as shown in Figure 7. The air in the tank is
pressurized to 50 kN/m2. Determine (a) the height h, to which the water rises, (b) the water
velocity in the pipe, and (c) the pressure in the horizontal part of the pipe.

CP211 TUTORIAL 5 2023/24


Figure 1

Figure 2
Figure 3

Figure 5
Figure 4

Figure 7
Figure 6

CP211 TUTORIAL 5 2023/24

You might also like