Finding Entry Opportunity Using Volume Spread Analysis in Trading
Finding Entry Opportunity Using Volume Spread Analysis in Trading
Analysis
Back to: Trading with Smart Money
In this article, I am going to discuss Finding Entry Opportunities using Volume Spread Analysis in Trading. Please
read our previous article, in which we discussed Volume Spread Analysis in detail. At the end of this article, you will
Risk to reward is favored when we trade from a support or resistance level. Generally, trade entry types are
SUPPORT
Support as the “buying, actual or potential, sufficient in DEMAND to halt a downtrend in prices for an appreciable
Resistance is the selling, actual or potential, insufficient supply to keep prices from rising for a time. and possibly
Flipping zone
Fibonacci retracement
These are the support and resistance zones where we have to find opportunities for trading. Generally, trade entry
types are
Weak Highs/Lows.
Testing
What is testing?
Usually, a successful test tells you that the market is ready to move immediately, while a higher volume test
usually results in a temporary move and will be re-tested at a later time in the same price area.
Important support and resistance points for testing include Weak Highs/Lows. Previous day high/Low and
day high/low
The test is employed to make sure that all the selling (supply) pressure has been absorbed in the accumulation
1. If they don’t find any supply below or demand above an important reference, they are confident that the
2. But if they do find it, then they usually follow through and test the next reference for the same.
So, our entry decision depends on opening the test in this support and resistance zone.
Flipping zone
Fibonacci retracement
Rule: If there is too much supply, the market will fall. If there is no more supply, the market must go up
Testing types (DEPEND OPEN THE SUPPORT AND RESISTANCE ZONE TYPE)
3. Test into an area of High Supply – Testing into the area of Stopping Volume or Selling Climax (reversal or
absorption)
Test variation
Swing test
Characteristics
The key is the volume. It should be less than the previous candle
Closes can be on the highs, but better when in the middle or near the high
A successful low-volume test tells you that the market is ready to rise immediately
Entry after seeing no supply candle in an uptrend
A No-Supply candle means that there is a lack of supply, and demand is overpowering supply, causing the
Please note that the No Supply candle is a continuation signal, not a reversal signal.
The background is important here, and this is only an entry to the long side if you have strength in the
1. Since we have the Bullish momentum. We can go long during an uptrend whenever no Supply Signal appears.
2. When you see No Supply with climactic action in the background, this indicates higher prices, so enter a buy
When the market is testing supply, any down-move dipping into an area or price range where there was previous
high volume (previous selling), which then returns to close on, or near the high, on lower volume, is a clear signal to
expect higher prices immediately. This is a successful test. Lower volume depicts that the amount of trading that
took place on the mark-down was reduced, that now there is less selling when previously there had been a lot of
selling. At this point, it is important to see how the market reacts to the strength seen in the testing.
Advertisements
Characteristic of SWING testing candle
2. The key is the volume. It should be less than the previous two bars
3. Closes can be on the lows, but better when in the middle or near the high
YOU MUST have strength in the background, such as stopping volume or selling climax. Place a stop under the low
of the climactic bar and place a buy order above the test bar. A test can fail, and you can re-test an area several
times before the market moves up, so placing an order above the test lets the market come to you. If the test fails,
market will continue to fall. If the stock recovers to the high and the volume is low, it would mean that there is no
supply. If the volume is high and the price fails to recover, it would mean that there is still supply present.
When the market is testing supply, any down move dipping into an area or price range where there was previous
high volume (previous selling ), which then returns to close on, or near the high, on lower volume, is a clear signal to
less selling when previously there had been a lot of selling. At this point, it is now important to see how the market
With the test now confirmed, the insiders can move the market higher to the target distribution level, confident that
If you are in a bearish market, you may see, at times, what appears to be a successful test. However, if the market
does not respond to what is normally an indication of strength after a successful test, this shows further weakness.
Any testing that does not respond immediately with higher prices, or certainly during the next candle or so, can be
considered an indication of weakness. If it were a true sign of strength, the smart money would have stepped in and
would be buying the market – the result of this smart money support would be the beginnings of an upward-
trending market. Specialists or smart money are never going to fight the market. If, in the smart money view, the
market is still weak these days, he will withdraw from trading. The market will then be reluctant to go up, even if it
looks like it should go up, because there was little or no selling on the ‘test’ candle.
Advertisements
However, what if the test fails and instead of low volume appearing, there is high volume, which is a problem? This
has resulted in sellers returning in large numbers and forcing the price to lower.
A higher volume test usually results in a temporary move and will be a re-test of the same price area again at a later
time. This action sometimes results in a “W/M” pattern. This volume price action is sometimes referred to as a
“double bottom (W)/double top (M)”. The “W” shape volume price action results from the action of re-testing an
area that had too much supply before. Vice versa for the “M” pattern
Please watch the following video if you want to learn and understand How to Find the Entry Opportunity using
In the next article, I will discuss the Spring and Upthrust Trading Strategy. In this article, I explain how to find entry
opportunities using volume spread analysis in trading. I hope you enjoy this Finding Entry Opportunities Using
Volume Spread Analysis in Trading article. Please join my Telegram Channel and YouTube Channel as well as
Pranaya Rout has published more than 3,000 articles in his 11-year career. Pranaya Rout has
very good experience with Microsoft Technologies, Including C#, VB, ASP.NET MVC, ASP.NET
Web API, EF, EF Core, ADO.NET, LINQ, SQL Server, MYSQL, Oracle, ASP.NET Core, Cloud
Computing, Microservices, Design Patterns and still learning new technologies.
← Previous Lesson Next Lesson →
RAJESH
JANUARY 8, 2023 AT 10:21 AM
Smart money concept and price action like pattern & support and resistance which is better
Reply
NEVO
AUGUST 23, 2023 AT 11:52 PM
as a VSA swing trader, In a daily chart- most tests are NOT with volume that lesser than the previous 2 bars behind
it, im trading the NYSE and NASDAQ.. in which time frames are you looking for tests for swing trades?
I found the test to be on low volume.. but not lesser than the previous 2 bars.. I’ll glad to understand the test
Reply
Leave a Reply
Your email address will not be published. Required fields are marked *
Comment *
Name*
Email*
Website
Post Comment
Price Action
Risk Management
VWAP Trading
Indicator
BTST
Chart Patterns
Trading Strategies
Darvas Box Trading Strategy
Top Mistakes to Avoid When Pullback Trading and How to Overcome Them?
Mastering Market Dynamics: Industry Rotation and Its Impact on Swing and Positional Trading Strategies
Trading Types
About Us Privacy Policy Contact ADO.NET Tutorial Angular Tutorials ASP.NET Core Blazor Tuturials
ASP.NET Core Tutorials ASP.NET MVC Tutorials ASP.NET Web API Tutorials C Tutorials
Data Structures and Algorithms Tutorials Design Patterns Tutorials DotNet Interview Questions and Answers
Core Java Tutorials Entity Framework Tutorials JavaScript Tutorials LINQ Tutorials Python Tutorials
SOLID Principles Tutorials SQL Server Tutorials Trading Tutorials JDBC Tutorials Java Servlets Tutorials
Java Struts Tutorials C++ Tutorials JSP Tutorials MySQL Tutorials Oracle Tutorials