Motor Written Dec
Motor Written Dec
Motor Written Dec
22 122
EXAMINATION OF MARINE ENGINEER OFFICER
Grade: MEO Class IV
Note:
) Answer SIX Questions only.
2) AllQuestions cary cqual marks
) Ncatncss in handwriting and clarity in
expression carries weightage
sketches/diagrams carries weightage.
4) lustration of an Answer with clear
5) Start answering trom the backside of the front cover page.
each question.
|6) Blank pages if any, to be strike off by (X) at the end of
[8)
I(a) Sketch and describe the Starting air system of main engine.
compressed air Starting systein of Main
(b) What are the safety interlocks provided in (8]
Engine?
these
crowns, outline the main stresses to which
2 (a) With retercnce to crankshafts and piston [4]
parts are subjected.
generated and how they vary in magnitude and
(b) Ineach case explain how the stresses are [6]
direction during one cycle
stresses may be accomimodated by good
(c) With respect to the whole engine describe how (6]
design and influenced by poor maintenance.
diagrams.? [6]
3(a) How power is calculated from Indicator
injection?
(b) Howdoes Indicator diagram show early fuel [5)
What are bad effects of too carly injection?
Injection on indicator diagram of the unit?
(c) What are indications of late [5]
the units?
What are bad effects of late injection of fuel on
page 1 of2
6 (a) Howisa 2-Stroke engine started?: Describe the sequcnce ofcngine starting
(b) Draw Timing Dugram of cngine starting, showing cruk position of cach step.
(c) What is OVERLAP incngine starting. (41
8(a) Drawsectional diagram of exhaust valve of 2 Stroke Diesel Engine. Name the different
(8]
components of the valve.
(b) Describe working of the valve in operation. How valve rotation occurs during operation (6]
and its purpose.
(c) What is the special material used on valve lid. (2)
9(a) What are the difficulties observed in lubrication of gear teeth in gear trains? (4]
(b) Describe with diagram, howgood lubrication to gear teeth is achieved? [6)
(c) What are the qualities of Lubricating oil suitable for main Reduction Gearing of main
engine? [6]
page 2 of2