Scribd Logo
Upload

Welcome to Scribd!

  • 6 views

    4.1.12 - SampleQuestions Automotive-Engineering V1

    Uploaded by

    Esha Thaniya Malla

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    4.1.12 - SampleQuestions Automotive-Engineering V1

    Uploaded by

    Esha Thaniya Malla
    6 views2 pages

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    6 views2 pages

    4.1.12 - SampleQuestions Automotive-Engineering V1

    Uploaded by

    Esha Thaniya Malla

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    Automotive Engineering

    1. For which of the following reason(s) is it advisable to lubricate all moving parts of an engine?
    A .To increase friction
    B. To reduce friction
    C. To increase velocity
    D. To reduce velocity

    a. Only A
    b. Only B
    c. Both A and C
    d. Both A and D

    2. What is the use of Damper spring in a clutch system?


    a. Softens the torsional vibration produced when the friction plate is pressed by the
    pressure plate
    b. To exert pressure on the driven plate
    c. Store kinetic energy and release it when needed,
    d. None of the above.

    3. Which of the following is a remedy for air in the hydraulic system problem?

    a. Bleed the system


    b. Adjust the brake pedal
    c. Use brake oil
    d. None of these

    4. The part of the rim that provides lateral support to the tire is known as ________.

    a. Well
    b. Bead seat
    c. Flange
    d. Gutter
    5. Which of the following is preferred to tighten cylinder head bolts?

    a. Ring spanner
    b. Ratcheting box wrench
    c. Open-ended spanner
    d. All of the above

    6. What is the use of distributor in a spark ignition engine?

    a. For providing correct firing order


    b. For breaking and mixing the fuel with air
    c. For providing high voltage to the spark plug
    d. For removing the burnt exhaust gases

    7. Which of the following statements is/are false?

    a. The spark plug gap is normally kept at 0.8 mm to 1.0 mm


    b. A fuel will detonate less if it has lower self-ignition temperature
    c. The relative fuel-air ratio (Fr) is equal to (chemically correct fuel air ratio)/actual fuel-air
    ratio
    d. All of the above

    8. Torque converter is a type of hydrodynamic coupling. What is the key characteristic of a torque
    converter?

    a. It transmits torque from the prime mover to the drive axles directly
    b. It multiplies torque when there is a substantial difference between input & output
    rotational speed
    c. It acts as a replacement of transmission to control the speed of the vehicle
    d. It decreases the torque at the wheels

    9. What is/are the thing(s) to check when an engine does not start/crank?

    a. Battery
    b. Fuel
    c. Clutch
    d. Brake oil
    e. Both a and b

    You might also like