Scribd
Upload
6 views2 pages

Pdf&rendition 1

Uploaded by

Suprithika Moddu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views2 pages

Pdf&rendition 1

Uploaded by

Suprithika Moddu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Embedded Systems Engineer Assignment

Objective:
Develop a small prototype system that demonstrates your expertise with STM32
microcontrollers, motor control, and ESP32 WiFi IoT connectivity.

Requirements:

Microcontroller Setup:
Design and implement a circuit using an STM32 microcontroller.
The STM32 should interface with at least one peripheral device (e.g., a sensor,
an ADC, or a display). Describe your choice and how it integrates with the
system.
Motor Control:
Integrate a small DC or stepper motor into your system.
Implement control logic on the STM32 to adjust the speed and direction of the
motor based on input from the peripheral device mentioned above.
WiFi Connectivity:
Use an ESP32 module to enable WiFi connectivity.
Develop firmware that allows the ESP32 to communicate motor status and any
sensor data to a simple web server or a mobile app.
Software:
Write the firmware for both the STM32 and ESP32.
Ensure your code is well-commented and follows best practices for readability
and maintainability.
Documentation:
Provide a schematic of your circuit.
Document the setup process, including any necessary steps to build and run your
project.
Outline any challenges you faced and how you resolved them.
Additional:
Implement additional features such as real-time monitoring or remote control
functionalities.
Enhance the system with power-saving features or error-handling mechanisms.

Deliverables:

Source code for both STM32 and ESP32.


Circuit schematic in PDF format.
A detailed project report that includes:
Project setup instructions.
A discussion of the system architecture.
An explanation of the code and design decisions.

Submission process

● Create Your Folder here


● In the drive, create a new folder. Name this folder using the format:
FullName__YourID
● Upload your PDF document to the folder you created.
● Right-click on the folder you created and select 'Share'.
● In the sharing settings, enter the email address [email protected].
● Set the permission to "Editor" so that the HR team can review your document
directly in the folder.

You might also like