0% found this document useful (0 votes)
115 views1 page

Tut#3

Uploaded by

relapsemr
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
115 views1 page

Tut#3

Uploaded by

relapsemr
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

University of Tripoli/ Faculty of Engineering Mechanical and Industrial Engineering Department

ME 313 Fluid Mechanics (II) Tutorial # 3 (ch. 8) Fall 2020


Problem 1: Cooling water is pumped
from a reservoir to rock drills on a
construction job using the pipe system
shown. The flow rate must be 600 gpm
and water must leave the spray nozzle at
120 ft/s. Calculate the minimum pressure
needed at the pump outlet. Estimate the
required power input if the pump
efficiency is 70 percent.
Ans: 341 psi

____________________________________________________________________________________________________________

Problem 2: Two reservoirs are connected by three clean cast-iron pipes in series, L1 = 600 m, D1 = 0.3
m, L2 = 900 m, D2 = 0.4 m, L3 = 1500 m, and D3 = 0.45 m. When the discharge is 0.11 m3/s of water
at 15° C. Determine the difference in elevation between the reservoirs. Ans: 8.13 m

____________________________________________________________________________________________________________

Problem 3: A pump is located


4.5 m to one side of, and 3.5 m
above a reservoir. The pump is
designed for a flow rate of 6
L/s. For satisfactory operation,
the static pressure at the pump
inlet must not be lower than - 6
m of water gage. Determine the
smallest standard commercial
steel pipe that
will give the required
performance.
Ans: 2 in

____________________________________________________________________________________________________________

Problem 4: Gasoline flows in a long, underground pipeline at a constant temperature of 15° C. Two
pumping stations at the same elevation are located 13 km apart. The pressure drop between the stations
is 1.4 MPa. The pipeline is made from 0.6-m-diameter pipe. Although the pipe is made from
commercial steel, age and corrosion have raised the pipe roughness to approximately that for
galvanized iron. Compute the volume flow rate. Ans: 1.01 m3/s

___________________________________________________________________________________________________________

Problem 5: A new industrial plant requires a water flow rate of 5.7 m3/min. The gage pressure in the
water main, located in the street 50 m from the plant, is 800 kPa. The supply line will require
installation of 4 elbows in a total length of 65 m. The gage pressure required in the plant is 500 kPa.
What size galvanized iron line should be installed? Ans: 6 in

__________________________________________________________________________________________________________

F. Gaseaa

You might also like