Gnodal GS7200

72 x 10 GbE ports in 1RU with latency of 150ns

The highest density, lowest latency 10 GbE ToR switch

GS7200 Features and Benefits

High Port Count
72 SFP+ ports, 1RU top-of-rack Ethernet switch enables network consolidation at minimal cost
Ultra-low Latency
150ns port-to-port with extremely low jitter making it ideal for latency sensitive applications
High Throughput
1.5 Tb/s non-blocking throughput and forwarding capacity exceeding 1 Bpps. Ideal for bandwidth hungry,
data-intensive applications in High Performance Data Centers
Scalability to Thousands of Ports
Unique top-of-rack switch due to its flexibility as edge or fabric device, 40 GbE support, arbitrarily wide
fabric link aggregation and MAC addressing up to 52 million entries, provides a cost-effective migration path
to future capabilities that protect investment
Layer2+
Service differentiation, lossless transmission, highly efficient multicast and unicast increases overall
application efficiency
Minimized TCO
Typical power consumption of 1.6W per port substantially reduces operating costs. Reliability and
serviceability are ensured with hot-swappable, redundant PSUs and fans
Standardization
SFP+ fiber or copper cables, open-sourced from third-party vendors or directly from Gnodal. Support of
QSFP to 4-port SFP+ converter cable enables further flexibility.

Gnodal GS-Series
Based on the Gnodal Peta ASIC, the GS7200 is part of the Gnodal GS-Series 10 and 40 GbE switches for the High
Performance Data Center. Gnodal derive their extreme performance capability from a revolutionary architectural
design that eliminates network congestion within multi-chassis configurations, delivering optimum performance
at minimum cost and power consumption.
The world’s fastest and only fully adaptive, load-balancing Ethernet Fabric
Gnodal GS7200 Technical Specifications

GS7200:72 SFP+ Port L2+ Switch IEEE Compliance MIB Support

Data coding & frame transmission Including RFC 1213, 1493, 2233, 2618,
802.3-2008 2665, 2674, 3412, 3413, 3414, 3415,
Port-to-port Latency Jumbo frames up to 9k 3584, 4133, 4363
72-port network: 150ns (RFC 1242 for IEEE 802.1X, 802.1AB, 802.3AD
Store and Forward) Bridge operation RSTP, MSTP
802.1D-2004. MAC Bridges DCBX (Priority-Based Flow Control)
Bandwidth Including 802.1w Rapid Spanning Tree RMON
72-port network: 1.5 Tbps non-blocking GVRP / GMRP
1071 million packets per second 802.1Q-2005 Virtual Bridged LANs Management & Administration
(VLANs) 1 GbE Management port (out of band)
Physical Including 802.1s Multiple Spanning Tree Serial Port
1 RU 19” rack-mountable 1.7” h x 17.5” w 802.1AX-2008 Link Aggregation Single-point, multi-chassis management
Dimensions: 1.73” x 17.52” x 22.44” 802.1AB-2005 Connectivity discovery Industry standard CLI Console
(4.4cm x 44.5cm x 57cm) (LLDP) Multi-session Telnet, SSH with pre-defined
Weight: 19.8 lbs (9.07 kg) 802.1X-2004 Port-Based Authentication commands
Airflow: Front-to-Rear (fan side to port Firmware & configuration upgrade
side) L2+ Features through TFTP & SFTP
Congestion Avoidance TCP/IP stack IPv4
Operating Environment Broadcast Storm & Flood Control Port mirroring
Temperature: 32° to 104°F (0° to 40°C) Lossless Transmission Selection SNTPv4
Relative humidity: 5 to 85 percent, Distributed Multi-Chassis LAG NTP
Non-condensing Span Aggregation
Max Operating Altitude: 9842 ft (3000m) Multicast
IGMP Snooping v1, v2 Regulatory Compliance
Electrical Characteristics MLD Snooping v1 Safety
CSA C22.2 No 60590-1:2007
Voltage Range (Vac): 100 – 240 V
QoS EN 60950-1,A1:2009
Nominal Frequency: 50 – 60 Hz
802.3x Flow Control IEC 60950-1, A1:2009
Prioritized Traffic Type CB Report Including all National
Power Consumption Priority-Based Flow Control Deviations
Maximum Power: 245W
Typical Power with Passive Twinax Security Electromagnetic Compatibility (EMC)
Copper: 114W Multiple User Privileges (CLI) AS/NZS CISPR 22: 2006, Class A
Typical Power with 72 x 10GBASE-SR: 1492 TACACS+ (authentication) Canada: ICES-003:2004
164W 2865 RADIUS (authentication) Europe: EN 55022: 2006, A1:2007 (CISPR
SSH IPv4 22: 2006), Class A
Connectivity RFC 3164 Syslog IPv4 USA: FCC CFR 47 Part 15, Subpart B,
10GbE SFP+ Passive / Active Copper or Class A
Fiber SNMP v1, v2, v3 (IPv4) CISPR24: 2001 A2:2002
10GBASE-CR – Direct Attach Copper Including RFC 1155, 1157, 1212, 1213, EN 55024: 1998 + A1: 2001 + A2: 2003
QSFP-SFP+ Breakout Cable 1215, 2089, 2578, 3411, 3412, 3413, EN 61000-3-2: A2 2009
10GBASE-SR 3414, 3415, 3416, 3417, 3584 EN 61000-3-3: 2008
10GBASE-LR
RoHS Compliance
Redundancy 2011/65/EU Restriction of Certain
1+1 redundant, hot-swappable PSUs Hazardous Substances Directive
2+1 redundant, hot-swappable fans
Environmental self-monitoring

Ordering Information for GS7200:

Part Number Description

GX-11101-02 Gnodal GS7200 1RU ToR switch, 72 SFP+ 10 GbE ports. Dual hot-swap PSUs. Includes rack-mount kit and power cords.

For further information please email: [email protected] or visit our website: www.gnodal.com
Items in italics supported in upcoming firmware releases
Gnodal makes no representations or warranties with respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions
at any time without notice. No license, whether express, implied, arising as a result of estoppels or otherwise, to any intellectual property rights is granted by this publication. Gnodal, the Gnodal logo and
combinations thereof are trademarks of Gnodal. The GS7200 port design is patent pending. Other product names used in this pub lication are for identification purposes only and may be trademarks of their
respective companies. Copyright © 2013 Gnodal Limited. All rights reserved.
260413

The world’s fastest and only fully adaptive, load-balancing Ethernet Fabric