Scribd
Upload
18 views2 pages

(B) Draw An Interfacing Scheme To Interface ADC08 - .

Uploaded by

Ayan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
18 views2 pages

(B) Draw An Interfacing Scheme To Interface ADC08 - .

Uploaded by

Ayan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Here's an interfacing scheme for connecting an ADC0809 Analog-to-Digital Converter (ADC)

with an 8051 microcontroller:

Components Required:

● 8051 Microcontroller (e.g., AT89S52)


● ADC0809 Analog-to-Digital Converter
● Resistors (1kΩ, 10kΩ)
● Capacitors (10µF, 100nF)
● Breadboard/PCB
● Connecting Wires

Connection Details:

1. Power Supply:
○ Connect Vcc of the ADC0809 to the +5V power supply.
○ Connect GND of the ADC0809 to the ground of the circuit.
2. Reference Voltage:
○ Connect a reference voltage (typically in the range of the analog signal you're
measuring) to the Vref+ pin of the ADC0809.
○ Connect the Vref- pin to ground (for single-ended measurements) or to a different
reference voltage for differential measurements.
3. Analog Input:
○ Connect the analog signal you want to convert to the IN+ pin of the chosen analog input
channel (IN0 to IN7) on the ADC0809.
○ Connect a 10kΩ resistor in series between the analog signal and the IN+ pin to limit
current.
○ Connect a 10nF capacitor in parallel with the resistor to filter out noise from the analog
signal.
4. Microcontroller Connection:
○ Connect the ALE (Address Latch Enable) pin of the ADC0809 to a port pin (e.g., P3.4)
on the 8051.
○ Connect the OE (Output Enable) pin of the ADC0809 to a port pin (e.g., P3.7) on the
8051.
○ Connect the START (Start Conversion) pin of the ADC0809 to a port pin (e.g., P3.5) on
the 8051.
○ Connect the EOC (End of Conversion) pin of the ADC0809 to a port pin (e.g., P3.6) on
the 8051 (can be used as input).
○ Connect the data output pins (D0 to D7) of the ADC0809 to port pins (e.g., P1.0 to P1.7)
on the 8051 to receive the converted digital data.

Additional Notes:

● A crystal oscillator and decoupling capacitors are typically required for the 8051's operation
(not shown here).
● The specific port pin assignments can be chosen based on your project's needs and
available resources on the 8051.
● Consult the datasheets of the ADC0809 and the 8051 microcontroller for detailed pin
descriptions and recommended operating conditions.

Diagram:

A visual representation of the interfacing scheme is difficult to include adhering to strict


guidelines without external image sources. However, the above description provides a clear
explanation of the connections.

You might also like