Scribd
Upload
17 views1 page

Assignment Task

Uploaded by

Duncan Juma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17 views1 page

Assignment Task

Uploaded by

Duncan Juma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DEDAN KIMATHI UNIVERSITY OF TECHNOLOGY

FOURTH YEAR FIRST SEMESTER (4.1)


FOR THE BACHELOR OF EDUCATION IN CIVIL ENGINEERING (B.Ed.)
& BACHELOR OF TECHNOLOGY IN BUILDING CONSTRUCTION (B.
Tech.)

ECE 4216: STRUCTURAL DESIGN II


Assignment Tasks.
1. A reinforced concrete beam has an overall depth of 500 mm and a width of 300 mm.
The beam is simply supported on 200 mm wide walls and spans 6 m. The beam is
exposed to mild conditions. The beam is to carry an imposed load of 25 kN/m and a
dead load of 15 kN/m (including self-weight). Assume fck =30 N/mm2, fyk = 460 N/mm2,
and fvk = 250 N/mm2, and design the beam together with the shear reinforcement.
2. A simply supported rectangular beam of 8 m span carries a uniformly distributed dead
load which includes an allowance for self-weight of 7 kN/m and an imposed load of 5
kN/m. The breadth of the beam is 250 mm. Find the depth and steel area when the depth
to the neutral axis is one-half the effective depth. Assume fck =30 N/mm2, fyk = 500
N/mm2.
3. The T-Section shown below is required to resist an ultimate moment of 300kN.m.
Determine the area of bending moment required using fck = 30 N/mm² and fyk = 500
N/mm².

You might also like