UACE Physics Paper 1 2
UACE Physics Paper 1 2
UACE Physics Paper 1 2
Answer five questions, including at least one, but not more than two from each sections A, Band C.
(b) A car of mass, m, travels round a circular track of radius, r, with velocity, V.
(i) Sketch a diagram to show the forces acting on the car. (02marks)
𝑎𝑟𝑔
(ii) Show that the car does not overturn if𝑉 2 < , where a is the distance between the
2ℎ
wheels, h, is the height of the centre of gravity above the ground and g is acceleration
due to gravity. (05marks)
(c) A pendulum bob of mass 0.2kg is attached to one end of an inelastic string of length
1.2m. The bob moves in a horizontal circle with the string inclined at 300 to the vertical.
Calculate
(d) Explain and sketch the variation of acceleration due to gravity with distance from the
centre of the earth (06marks)
(b)
A mass of 1.0kg is hang from two springs S1 and S2 connected in series as shown above.
The force constant of the springs are 100Nm-1 and 200Nm-1 respectively. Find
(c) Explain with the aid of a sketch graph, what would happen to the oscillations in (b)(ii)
above if the mass was immersed in a liquid such as water. (04marks)
SECTION B
(b) (i) Describe the steps taken to establish a temperature scale. (05marks)
(ii) Explain why two thermometers may give different values for the same unknown
temperature. (02marks)
(c) (i) Describe, with the aid of a diagram, how a constant-volume gas thermometer may be
used to measure temperature. (06mrks)
(ii) State three corrections that need to be made when using the thermometer in (c)(i)
above. (03marks)
(iii) State and explain the sources of inaccuracies in using mercury in glass
thermometer, (02marks)
6. (a) Define thermal conductivity of a material and state its units (02marks)
(b) Describe with the aid of a diagram how the thermal conductivity of a poor conductor can
be determined. (07marks)
(c) A cooking saucepan made of iron has a base area of 0.05m2 and thickness of 2.5mm. It
has a thin layer of soot of average thickness 0.5mm on its bottom surface. Water in the
saucepan is heated until it boils at 1000C. The water boils away at a rate of 0.60kg per
minute and the side of the soot nearest to the heat source is at 1500C. Find the thermal
conductivity of soot.
[Thermal conductivity of iron = 66Wm-1K-1and specific latent heat of vaporization
=2200kJ/kg)
(ii) Sketch the spherical distribution of black body radiation for three different
temperatures and describe their main features. (04marks)
1
7. (a) Derive the expression P = 𝜌𝑐 2̅ for the pressure, P, of an ideal gas of density ρ and mean
3
̅
2
square speed, 𝑐 . State any assumptions made (07marks)
(b) A gas is confined in a container of volume 0.1m3 at a pressure of 1.0 x 105Nm-2 and
temperature of 300K. If the gas is assumed to be ideal, calculate the density of the gas.
(The relative molecular mass of the gas is 32) (05marks)
(c) What is meant by
(i) isothermal change
(ii) adiabatic change (02marks)
(d) A gas at a pressure of 1.0 x 106Pa is compressed adiabatically to half its volume and then
allowed to expand isothermally to its original volume. Calculate the final pressure of the
gas.
𝑐
[Assume the ratio of the principal specific heat capacities 𝑝⁄𝑐𝑣 , 𝛾 = 1.4] (06marks)
SECTION C
8. (a) (i) Describe with the aid of a labelled diagram the main features of a cathode ray
oscilloscope (C.R.O) (08marks)
(ii) State two uses of C.R.O (01mark)
(iii) The gain control of a C.R.O is set on 0.5Vcm-1 and an alternating voltage produces a
vertical trace of 2.0cm long with the time base off. Find the root mean value of the
applied voltage. (02marks)
(b) a beam of electrons is accelerated through a potential difference of 2000V and is
directed mid-way between two horizontal plates of length 5.0cm and separation of
2.0cm. The potential difference across the plates is 80V.
(i) Calculate the speed of the electron as they enter the region between the plates.
(03marks)
(ii) Explain the motion of the electrons between the plates. (02marks)
(iii) find the speed of electrons as they emerge from the region between the plates.
(04marks)
9. (a) Explain the term stopping potential as applied to photo electric effect. (02marks)
(b) Explain how intensity and penetrating power of X-rays from X-ray tube would be
affected by changing:
(i) the filament current (02marks)
(ii) the high tension potential difference across the tube (02marks)
(c) When a p.d of 60kV is applied across an X-ray tube, a current of 30mA flows. The anode
is cooled by water flowing at a rate of 0.060kgs-1. If 99% of the power supplied is
converted into heat at the anode, calculate the rate at which the temperature of the
water rises. {Specific heat capacity of water = 4.2 x 103Jkg-1K-1] (05marks)
(d) (i) Derive Bragg’s law of X-ray diffraction. (05marks)
(ii) Calculate the atomic spacing of sodium chloride if the relative atomic mass of sodium
is 23.0 and that of chlorine is 35.5.
[Density of sodium chloride = 2.18 x 103kgm-3] (04marks)
10. (a) (i) Explain briefly the mechanism of thermionic emission. (02marks)
(ii) Draw a labelled diagram of the circuit used to determine the anode current and
anode voltage characteristics of a thermionic diode. (02marks)
(iii) Sketch the characteristic expected in (a) (ii) at constant filament current, and account
for its special features. (04marks)
(b) Describe, with the aid of a labelled diagram, the structure and action of a diffusion cloud
chamber (06marks)
(c) (i) Define radioactivity and half-life of a radioactive substance (02marks)
(ii) A radioactive isotope of strontium of mass 5.0μg has a half-life of 28years. Find the
mass of the isotope left after 14 years. (04marks)