Dfia Fike
Dfia Fike
Description
The Direct Fired Impulse Actuator (DFIA) Kit includes the primary components
required to actuate Fike’s Impulse Valve clean agent containers from a
compatible releasing panel. The kits primary component is the DFIA, which
provides both an automatic and manual means of activating the valve it is
connected to. Automatic activation of the DFIA is accomplished by applying 24
VDC power from the host releasing control panel or releasing device to the
DFIA. This will cause the DFIA’s firing piston to extend and open the valve’s
rupture disc, allowing the agent to be released from the container. Manual DFIA (Item 1)
activation of the DFIA can be accomplished by striking the RED button on the
DFIA itself.
The kit also includes an Impulse Valve Operator Supervisor (IVOS) that when
installed monitors the connection of the DFIA to the impulse valve itself. When
the IVOS is removed, it will cause a “Supervisory event” at the releasing control
panel indicating that the DFIA has been disconnected from the valve,
essentially disabling the suppression system.
Compatibility
The Notifier FCM‐1‐REL releasing control module has been compatibility tested
for use in activating the DFIA. Maximum one DFIA per module. In addition, the
FCM‐1‐REL module provides the required supervision of the releasing circuit
wiring (open and ground fault conditions) from the impulse valve clean agent
container to the compatible releasing panel. Refer to Notifier’s Device IVOS (Item 2)
Compability document number 15378 for DFIA compatibility.
Ordering Information
DIRECT FIRED IMPULSE
P/N 70‐342‐1
ACTUATOR (DFIA) KIT
The following items are furnished with the DFIA Kit:
Item Part
Description
No. Number
1 02‐14554‐1 Direct Fired Impulse Actuator (DFIA)
2 02‐14263 Impulse Valve Operator Supervisor (IVOS)
3 02‐13130 Cotter Pin (not shown)
4 02‐2213 Security Tie (not shown)
5 02‐12925 Black Plastic Cap (not shown)
6 06‐875 DFIA Installation Instructions
This document is not to be used for installation purposes and is subject to Fike’s full disclaimer at Page 1 of 2
http://www.fike.com/disclaimer.
Form No. IV.1.24.01
Fike reserves the right to change product designs or specifications without obligation and without further notice. July, 2017
Specifications
DIRECT FIRED IMPULSE ACTUATOR (DFIA), P/N 02‐14554‐1
Supply Voltage 24 VDC nominal (15.6 – 29.5 VDC range)
Alarm = 420 mA maximum
Current Consumption
Standby = Consult Notifier’s FCM‐1‐REL documentation
Electrical Connection Cable & ½” NPT for conduit connection
DFIA Material Stainless Steel (Body) / Brass (End Cap)
Temperature Range 32° F to 130° F (0° C to 54.4° C)
Listings & Approvals UL / ULC Listed & FM Approved
General Assembly
Impulse Valve
Actuator Port
Wire Leads
½” NPT Female
Conduit Connection
Page 2 of 2 Visit www.fike.com to contact us or to download the latest version of this document.
Form No. IV.1.24.01 © Copyright 2017, Fike Corporation. All rights reserved.
July, 2017 Fike is an ISO 9001 Certified Company.