Practical 9

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 6

PRACTICAL

AIM: Introduction to EPB28335.

Overview of the EPB28335

The EPB28335 is a stand-alone card--allowing developers to evaluate the TMS320F28335


digital signal controller (DSC) to determine if it meets their Application requirements.
Furthermore, the module is an excellent platform to develop and run software for the
TMS320F28335 processor.

The EPB28335 is shipped with a TMS320F28335 DSC. The EPB28335 allows full speed
verification of F28335 code.

To simplify code development and shorten debugging time, a C2000 Code Composer Studio
driver is provided. In addition, an onboard JTAG connector provides interface to emulators,
with assembly language and ‘C’ high level language debug.
1.1
Key Features of the EPB F28335

1.1.1 Hardware Features

 TMS320F28335 Digital Signal Controller


 150 Mhz. Max operating speed
 On chip 32-bit floating point unit
 68K bytes on-chip RAM
 512K bytes on-chip Flash memory
 On board 1M bytes (64kx16) off-chip SRAM memory
 9-volt only operation with supplied AC adapter
 On board Power-On LED indication
 Connector for Watchdog timer output
 20 Pin (10x2 header) Connector for 16 GPIO lines
 DB25 Connector for 8 Digital Input and 8 Digital Output interface with +5V
compatibility
 Error + Trip +5V compatible connector for Inverter control module
 On board USB Connector for UART-A interface with LED indication
 On board USB for Flashing
 On board DB9 connector for UART-A interface
 On board LED indication for Transmit and Receive data at UART-A
 On board 3 pin header for UART-B interface
 On board DB9 connector for CAN-A interface (Loop back mode possible)
 On board 4 pin header for CAN-B interface (Loop back mode possible)
 On board DB9 connector for 6 channel capture interface
 On board DB25 connector for 12 channel PWM interface
 On board DB15 connector for 8 Channel On-Chip ADC-A interface (with 3V protection
using Op-Amps with unity gain output)
 On board DB15 connector for 8 Channel On-Chip ADC-B interface (with 3V protection
using Op-Amps with unity gain output)
 On board Potentiometer to test On-Chip ADC
 On board DB9 connector for 4 channel SPI based External DAC interface
 On board I2C based Off-Chip EEPROM interface
 On board I2C based Off-Chip RTC interface
 On board Reset Switch with LED indication
 On board Switch for Run/Program mode switching
 On board Switch for boot mode selection
 On board IEEE 1149.1 JTAG emulation connector (7x2 pins) with LED indication
 Test points for All the PWM channels
 Test points for All the ADC channels
 Test points for Power signals
 On board LED at GPIO Pin as GPIO Test point
1.1.2 Software Features

 TI F28xx Code Composer StudioTM Integrated Development Environment, Version


3.3
 Texas Instruments’ Flash APIs to support the F28335
 Texas Instruments’ F28335 header files

1.2 Functional Overview of the EPB28335

1.2.1 Figure shows a block diagram of the basic configuration for the TMS320F28335.
1.2.2 Figure shows a block diagram of the basic configuration for the EPB28335.

You might also like