0% found this document useful (0 votes)
2K views4 pages

Edc Imp Questions

Uploaded by

praneethgowda11
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
2K views4 pages

Edc Imp Questions

Uploaded by

praneethgowda11
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

ANURAG Engineering College

(An Autonomous Institution)


(Affiliated to JNTUH-Hyderabad, Approved by AICTE-New Delhi)
Ananthagiri (V&M), Kodad, Suryapet(Dt). Telangana, Pin: 508 206.
DEPARTMENT OF ELECTRONICS AND COMMUNICATION ENGINEERING

ELECTRONIC DEVICES AND CIRCUITS


UNIT I
DIODE

SHORT ANSWER QUESTIONS

1.What is the cut-in voltage for Silicon and germanium diodes


2.An ideal diode in forward-bias acts as
3.Write diode current equation
4.VI characteristics of PN junction diode is
5.Draw the ideal diode characteristics
6.Define reverse saturation current of PN junction diode
7.Define Diffusion capacitance
8.Define Transition capacitance
9.What are equivalent circuits of diode
10.Define diode

LONG ANSWER QUESTIONS

1.With neat diagram explain the working of PN junction diode in forward bias and reverse bias with volt-
ampere characteristics
2.Write in detail about static and dynamic diode resistances
3.Derive the expressions for diffusion capacitance of PN junction diode
4.Derive the expressions for transition capacitance of PN junction diode
5.How diode is used as a switch and explain its switching times
6.Explain volt-ampere characteristics of PN junction diode and show the effect of temperature on it
7.Write about equivalent circuits of PN junction diode
UNIT II
DIODE APPLICATIONS & CLIPPERS AND CLAMPERS

SHORT ANSWER QUESTIONS

1.What are the applications of PN junction diode


2.Define Rectifier
3.What is the ripple factor of halfwave rectifier and full wave rectifier
4.Define clipper
5.What do you mean by clamper
6.Define efficiency and what is the efficiency of halfwave and full wave rectifier
7.Classify clamper circuits
8.Define filter
9. What is clamping circuit theorem
10.Define ripple factor

LONG ANSWER QUESTIONS

1.Explain the working of halfwave or full wave rectifier with the help of waveforms and also derive its
ripple factor/efficiency/TUF
2.Explain the working of bridge rectifier with the help of waveforms and also derive its efficiency
3.With neat diagram explain the working of half wave/full wave rectifier with L/C/LC/CLC-section
filter and also derive the expression for ripple factor
4.Explain the operation of positive and negative clamping circuits
5.Design a clipping circuit that clips at two independent levels
6.State and prove clamping circuit theorem

UNIT III
BIPOLAR JUNCTION TRANSISTOR(BJT)

SHORT ANSWER QUESTIONS

1.What is the increasing order for size of BJT terminals


2.What is the order of doping concentration for regions of BJT
3.Define transistor and classify transistors
4.What are the regions of operation of transistor
5.What are the applications of transistor
6.Compare CB, CE & CC transistor configurations
7.Draw PNP and NPN transistor symbols.
LONG ANSWER QUESTIONS

1.Explain the construction and operation of NPN Transistor


2.Explain the construction and operation of PNP Transistor
3.With neat diagram explain the input-output characteristics of BJT for CB / CE / CC configuration
4.Explain Transistor switching characteristics in detail
5.With neat diagram explain Transistor as a switch

UNIT IV
JUNCTION FIELD EFFECT TRANSISTOR(FET)

SHORT ANSWER QUESTIONS

1.JFET, D-MOSFET, E-MOSFET stands for_______________________


2. Draw Symbol of N-channel JFET, P-channel JFET, P-channel E-MOSFET, N-channel E-MOSFET, P-
channel D-MOSFET and P-channel D-MOSFET
3.Write relation between FET parameters and define them.
4.FET is __________________ Variable resistor
5.Why FET is called as Voltage controlled device.
6.Classify FETs.
7.Define pinch-off voltage

LONG ANSWER QUESTIONS

1.Explain construction, working and V-I Characteristics of N-channel or P-channel JFET.


2.Explain construction, working and V-I Characteristics of N-channel or P-channel Enhancement
MOSFET.
3.Explain construction, working and V-I Characteristics of N-channel or P-channel Depletion MOSFET
4.Explain, how MOSFET acts as a capacitor.
5.Compare BJT and FET.
6.Explain FET as a voltage variable resistor
UNIT V
SPECIAL PURPOSE DEVICES

SHORT ANSWER QUESTIONS

1.What are the applications of Photo Diode, Zener Diode, Photo Diode, Tunnel diode and varactor diode.
2. Draw V-I characteristics of Schottky Barrier Diode, Photo Diode, Zener Diode & Tunnel diode
3. Draw symbol of LED.
4. Draw symbol of Schottky Barrier Diode.
5. Draw symbol of UJT.
6. Draw Characteristics of Solar Cell
7. SCR stands for_______________________________

LONG ANSWER QUESTIONS

1. Explain V-I characteristics of Zener diode with neat diagrams and also explain Zener diode as a voltage
regulator.
2.Explain operation, V-I Characteristics of Tunnel Diode.
3.Explain operation, V-I Characteristics of SCR.
4.Explain operation, V-I Characteristics of Schottky Diode.
5.Explain operation, V-I Characteristics of Varactor Diode.
6. Draw the symbol and equivalent circuit of a UJT. Explain the operation of UJT with the help of its I-V
characteristics.

You might also like