Bae 146

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 6

Powering on the aircraft

Checks

Center console: WX: off and tilt 15° up

XPDR: stdby

Flaps and speed brake: up

Batt 1 and 2: on (check the voltage abv 25)

Nav lights: HI INT

No smoking signs: auto

Emergency lights: arm

Gear lever: down and 3 greens

Park brake: yellow hyd and fully pulled back.

MISC panel: all masters on

Anti-skid

Ylw and grn spoilers

Electric panel: BUS ties: auto

Stdby inv and gen to arm

APU: APU gen on

L.inner fuel pump on

Start APU: monitor.

After avail light on: APU air ON

After that turn on pack 1 or 2

F/O side, push the red button fully in to perform the master warning system test.

Check that all the lights are on

After the test, pull the red button to the middle position.

Hydraulics test:

DC pump to ON: increase in ylw hyd press.

After the test, DC pump OFF.

Do the same with the AC pump, it will pressurize the ylw hyd fully

With the ylw hyd sys fully pressurized, PTU test : PTU ON

Aft sufficient pressure, turn off PTU and AC pump


ENG start prep

ENG anti ice on x4

F deck emer lights to ARM

Pedestal: YD to ON

PASSENGER BOARDING THROUGH EFB

Engine start
Before start Checklist

 Park Brake ON
 Brake accu press SUFFICIENT (if yellow under 2500 then DC pump ON)
 Thrust levers FUEL OFF
 Hydraulics ALL OFF
 Center tank transfer AUTO
 Press panel MODE SELECTOR: AUTO DISCH VALVES: NORM
 Set cruise alt for pressurization purposes.
 Ice detect ON
 Fuel CHECK (CROSS CHECK WITH TABLET)
 Flight recorder (f/o) CHECK DATE AND FLIGHT LEG
 Pedestal ATC/FID set FLIGHT NUMBER and “enter.”
 TMS check PWR—TEST—outside temp “set.”
 TMS prep set to TO and TGT temp to 840°
 Thrust setting click note pad next to TMS.
 Final TK OFF speed RETRACT FLAPS
 TMS before start OFF

Flight plan set up.


 FD ON
 VOR-VOR
 VHF NAV ON and knob next to that to ON
 After VHF NAV ON enter frequency of VOR and set NAV1 course
 HDG for TO set HDG to RNY heading and engage HDG mode.
 Altitude select TGT ALT and ALT ARM
 ADF Tune
 On the compass Left VOR right ADF
 HSI NAV
 VHF radios ON
 OFP RNAV
Passenger boarding
When complete:

AC pump ON

Then retract stairs.

After stairs have been retracted AC pump OFF

Pushback and engine start


 Seat belt signs ON
 Beacon lights ON
 Packs and APU air OFF
 Fuel pumps ON
 Park brakes OFF
 *pushback*
 Pushback complete PARK BRAKE SET
 Start master ON
 Engine selector 4
 Engine start switch PRESS FOR 1 SECOND
 When N2=10% ENG 4 THRUST LEVER: FUEL ON
 Once stabilized REPEATE FOR REMAINING ENGINES
 When all 4 started ENG SELECTOR: OFF and START MASTER: OFF
 If no icing expected ANTI ICE: OFF

After start
 Gen 1 and 4 ON
 APU air and packs 1-2 ON
 Brake fans AUTO
 ENG 2 and 3 pumps ON and MONITOR
 Once at 3000 PSI AC pump and PTU: ON
 Ice protection panel HTRS: ON all
 TMS ON and TO mode
 XPDR TA
 Flaps TAKE OFF
 Taxi lights ON

Before take-off
 Trim setting Click CG% on EFB
 Config check (pedestal) PARK BRAKE: OFF
 Cabin call LEFT of ovhd panel.
 Lights LDG and STROBE
 FCTL check UNLOCK CONTROL COLUMN AND CHECK

 Engine thrust check 55% N1 then SET TO THRUST


 Perform after take-off checks
 GEAR AND FLAPS UP
 ENGINE AIR SWITCHES ON X4 AND APU AIR OFF
 AC PUMP AND PTU OFF
 APU OFF
 Cabin CABIN CALL TO ALLOW SERVICE
 10000ft LDG LIGHTS OFF/SIGNS OFF
 Speed increase SYNC MODE – PITCH DOWN – SYNC MODE OFF
 IF USING VOR-VOR ACT/PRE switch to PRE – SELECT FREQUENCY
 ONCE 5NM MATCH HDG – HDG MODE – SWITCH FREQ – PRESEL CRS – V/L
 Once at CRZ FL CHECK CABIN (F/O) AND SPEED

Descent
 Select altitude ILS INTCPT ALT
 Thrust DESC MODE – THRUST LEVERS : IDLE
 Descent process AP SYNC MODE – 2000FT/M – ENGAGE VS MODE
 DES Speed 250 IAS
 ILS TUNE FREQUENCY – TUNE NDB (ADF 2)
 Minimums SET (DH)

DESCENT CHECKLIST
 PTU ON
 LDG ALT SET
 SPEEDS SET – Vfto and Ver SET (white and red)
 10000ft LDG LIGHTS – SIGNS: ON
 TRANS LEVEL SET QNH
 5000ft APU ON
 ILS PLATEAU INFORM CABIN
 LOC G/S ARM

LANDING CHECKLIST
 AC pump AUTO
 APU AIR ON
 Engine AIR OFF

LANDING
 RNY Threshold EXTEND SPOILERS
 On touch down APPLY BRAKES AND LIFT SPOILER

After landing checklist


 Spoilers UP
 Flaps UP
 TMS OFF
 XPDR STDBY
 Lights LDG: OFF – TAXI: ON – STROBE: ON

Parking checklist
 Cabin DEPRESSURIZED
 MWS (red switch) GROUND OP
 HYD pumps OFF ALL
 GEN 1-4 OFF/RESET
 Thrust levers FUEL CUT OFF
 Signs OFF
 Pumps OFF EXCEPT L.INNER
 Heaters OFF
 ICE detect OFF
 Beacon OFF
 EFB
 Chocks SET
 Stairs OPEN
 Cargo doors OPEN

Complete shut off (cold and dark)


 Masters OFF
 Brake fan OFF
 Anti-skid OFF
 LFT spoilers YELLOW AND GREEN: OFF
 Emergency lights OFF
 Packs OFF
 APU AIR OFF
 APU OFF: GRND TEST PNL – APU OVSPD
 Once APU RPM 0 MASTER OFF
 L.INNER pump OFF
 Galley switch SHED
 ALL lights OFF
 Batteries 1-2 OFF

You might also like