Scribd
Upload
33 views1 page

CO Imp Questions

Uploaded by

rakeshkolupuru9
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
33 views1 page

CO Imp Questions

Uploaded by

rakeshkolupuru9
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

COMPUTER ORGANISATION IMPORTANT QUESTIONS

By B.Chandra Mouli
UNIT-I-Basic Computer organisation
1. Define i. Micro operation ii. Microinstruction iii. Micro program
2. Tabulate the logical and shift micro operations with its RTL(Register transfer language)
notations.
3. Draw the block diagram of arithmetic logic shift unit and explain its operations.
4. What is Micro operation? Briefly explain the arithemetic micro operations?
5. Discuss about Arithematic shift operation with block diagram.
6. Explain about shift micro operations with examples
UNIT-II-Computer arithematic
1. Discuss about 9’s compliment subtraction with few examples.
2. Discuss about 10’s compliment subtraction with few examples.
3. Design hardware for signed magnitude addition and subtraction?
4. Explain the process for signed magnitude addition and subtraction with flow chart.
5. Explain the Booth’s algorithm for multiplication of signed two’s complement
numbers.
6. Explain algorithm for unsigned integer division method with an example.
7. Explain How BCD addition is performed in a basic computer with block diagram.
8. Discuss about BCD arithematic and its implementation in computers.

UNIT-III-Control unit and I/O interfaces


1. Discuss about the importance of input -output interfaces in computer organisation.
2. Discuss about Isolated IO and memory mapped IO.
3. What is an instruction cycle and write the phases of Instruction cycle?
4. Write in detail about Micro program control unit and mention how it is advantageous
compared to hardwired methodology.
5. Explain Hardware control unit.
6. Elaborate on microinstruction format.
7. Draw and explain the schematic of Micro program sequencer for a control memory.
8. Demonstrate the general configuration of Micro programmed Control unit with a
neat block diagram
9. Explain with the block diagram the DMA transfer in a computer system
10. Discuss the design of a typical input or output interface.
11. Explain in detail about strobe control method of asynchronous data transfer?
12. Classify and describe the possible modes of data transfer to and from peripherals
with examples.
13. List out the methodologies involved in handling Priority Interrupt
14. With a neat schematic, Explain about DMA controller and its mode of data transfer
15. Discuss about asynchronous data transfer in detail.

You might also like