Scribd
Upload
7 views2 pages

2

Uploaded by

avi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as RTF, PDF, TXT or read online on Scribd
7 views2 pages

2

Uploaded by

avi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as RTF, PDF, TXT or read online on Scribd
You are on page 1/ 2

Module 6

Materials and Hardware

Exam 2

1. Forming a solution treated rivet gives it 75% of its


hardness. What gives it the other 25%?

a) Put them in a refrigerator


b) Precipitation treat the component when forming is
complete
c) Leave at room temperature for four hours

2. What two components of a three part polyester resin are


dangerous to mix together directly?

a) Accelerator and free catalyst


b) Catalyst and resin
c) Accelerator and resin

3. What is the effect of adding too much hardener to a


resin?

a) The resin will not harden


b) Makes the repair more brittle
c) No effect

4. How many times can clad alloy be heat treated?

a) 3 times
b) as many times as required
c) Once only

5. Two parts of the adhesive process are

a) wetting and setting


b) wetting and gripping
c) spreading and setting

6. What is the largest hole in honeycomb repairable with


microballoons?

a) 2.54 cm
b) 2.54 inches
c) 2.54 mm
7. If D or DD rivets are not formed in time , or removed
from the freezer in time, they

a) must be re-heat treated before use


b) can be re-heat treated once then discarded
c) must be discarded

8. How are flexible hoses categorised?

a) by length
b) by maximum pressure
c) by diameter

9. A joggle in a removed rivet is indication of what type


of partial failure?

a) Shear
b) Bearing
c) Compression

10. Over extended honeycomb can bend in which direction?

a) In all directions
b) Across the ribbon
c) Along the ribbon

You might also like