0% found this document useful (0 votes)
13 views4 pages

Advanced Networking and Communication: CS/BCA/SUPPLE/SEM-6/BCAE-601A/2010

Uploaded by

papai sarkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
13 views4 pages

Advanced Networking and Communication: CS/BCA/SUPPLE/SEM-6/BCAE-601A/2010

Uploaded by

papai sarkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

http://www.makaut.

com

Name : ……………………………………………………………
Roll No. : ………………………………………………………..
Invigilator's Signature : ……………………………………….
CS/BCA/SUPPLE/SEM-6/BCAE-601A/2010
2010
ADVANCED NETWORKING AND COMMUNICATION
Time Allotted : 3 Hours Full Marks : 70

The figures in the margin indicate full marks.


Candidates are required to give their answers in their own words
as far as practicable.

GROUP – A
( Multiple Choice Type Questions )

1. Choose the correct alternatives for the following :


10 × 1 = 10
i) A device operating at the physical layer is called

a) Bridge b) Router

c) Repeater d) none of these.

ii) For separating channels in FDM, it is necessary to use

a) Time slots b) Band pass filters

c) Differentiation d) none of these.

iii) Encryption and decryption are function of

a) Transport layer b) Session layer

c) Presentation layer d) none of these.

SE-113 [ Turn over


CS/BCA/SUPPLE/SEM-6/BCAE-601A/2010

iv) Frame relay technique uses


a) Circuit switching
b) Connection oriented packet switching
c) Message switching
d) Hybrid switching.
v) Which of the following networks requires all channels in
a message transmission path be of the same speed ?
a) Packed switched networks
b) Circuit switched networks
c) Message switched networks
d) None of these.
vi) FDDI is
a) Bus topology b) Ring topology
c) Star topology d) none of these.
vii) Token Bus is
a) IEEE 802.2 b) IEEE 802.3
c) IEEE 802.4 d) IEEE 802.6.
viii) ISDN's BRI service has ........... B channel(s) and ...........
D channel(s).
a) one, one b) one, two
c) two, one d) none of these.
ix) TCP/IP is a/an
a) Reliable connection oriented protocol
b) Unreliable connection oriented protocol
c) Reliable connectionless protocol
d) Unreliable connectionless protocol.

SE-113 2
CS/BCA/SUPPLE/SEM-6/BCAE-601A/2010

x) Unmodulated signal coming from a transmitter is called


a) Carrier signal b) Baseband signal
c) Frequency signal d) all of these.

GROUP – B
( Short Answer Type Questions )
Answer any three of the following. 3 × 5 = 15
2. Differentiate between Character oriented protocol and
Bit oriented protocol.
3. What is LLC ? Explain.
4. With the help of a suitable diagram, describe an ATM cell.
5. Explain the following terms :
Unicast, Multicast and Broadcast.
6. What is Transmission impairment ? What are its causes ?
2+3
GROUP – C
( Long Answer Type Questions )
Answer any three of the following. 3 × 15 = 45
7. a) An ISP is granted a block for addresses starting with
120.60.4.0./22. The ISP needs to distribute these
blocks to 100 organizations with each organization
receiving just eight addresses.
Design the sub-blocks and give the slash notation for
each sub-block. Find out how many addresses are still
available after these allocations. 11
b) What is a transparent bridge ? 4
8. a) Explain the Stop and Wait protocol. 5
b) What is IEEE 802.6 ? 5
c) Write the advantages of optical fibre over twisted pair
and coaxial cable. 5

SE-113 3 [ Turn over


CS/BCA/SUPPLE/SEM-6/BCAE-601A/2010

9. a) Why do we need a DNS system when we can directly


use an IP address ? 5

b) Differentiate between 'Symmetric Key Cryptography' and


'Asymmetric Key Cryptography'. 5

c) Explain the RSA algorithm. 5

10. a) Differentiate between TCP and UDP. 6

b) Five channels, each with a 100 kHz bandwidth, are to


be multiplexed together. What is the minimum
bandwidth of the link if there is a need for a guard band
of 10 kHz between the channels to preventinterference ?

c) Distinguish between Virtual Circuit and Datagram


Subnet. 5

11. Write short notes on any three of the following : 3×5

a) RIP

b) There-way Handshake protocol

c) Circuit switching

d) ISDN

e) ATM.

SE-113 4

You might also like