Scribd
Upload
72 views5 pages

R1 (Config) #Interface Ethernet0/0.20 R1 (Config) #Encapsulation Dot1q 20 R1 (Config) #Ip Address 10.20.20.1 255.255.255.0

Uploaded by

shhhgmg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
72 views5 pages

R1 (Config) #Interface Ethernet0/0.20 R1 (Config) #Encapsulation Dot1q 20 R1 (Config) #Ip Address 10.20.20.1 255.255.255.0

Uploaded by

shhhgmg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

C.

The phone sends and receives data in VLAN 50, but a workstation connected to the
phone has no VLAN connected.
D. The phone and a workstation that is connected to the phone send and receive data in
VLAN 50.
21.

A.
R1 (config)#interface ethernet0/0
R1 (config)#encapsulation dot1q 20
R1(config)#ip address 10.20.20.1 255.255.255.0
B.
R1 (config)#interface ethernet0/0.20
R1 (config)#encapsulation dot1q 20
R1(config)#ip address 10.20.20.1 255.255.255.0
C.
R1 (config)#interface ethernet0/0.20
R1(config)#ip address 10.20.20.1 255.255.255.0
D.
R1 (config)#interface ethernet0/0
R1(config)#ip address 10.20.20.1 255.255.255.0
22.

A. The source MAC address is changed


B. The source and destination MAC addresses remain the same
C. The destination MAC address is replaced with ffff.ffff.ffff
D. The switch rewrites the source and destination MAC addresses with its own
23. An engineer must establish a trunk link between two switches. The neighboring switch is
set to trunk or desirable mode. What action should be taken?
A. configure switchport nonegotiate
B. configure switchport mode dynamic desirable
C. configure switchport mode dynamic auto
D. configure switchport trunk dynamic desirable
24. An engineer must configure interswitch VLAN communication between a Cisco switch
and a third-party switch. Which action should be taken?
A. configure IEEE 802.1p
B. configure IEEE 802.1q
C. configure ISL
D. configure DSCP
25. Which two statements about EtherChannel technology are true? (Choose two)
A. EtherChannel provides increased bandwidth by bundling existing FastEthernet or Gigabit
Ethernet
interfaces into a single EtherChannel
B. STP does not block EtherChannel links
C. You can configure multiple EtherChannel links between two switches, using up to a limit
of sixteen
physical ports
D. EtherChannel does not allow load sharing of traffic among the physical links within the
EtherChannel
E. EtherChannel allows redundancy in case one or more links in the EtherChannel fail
26. Which mode must be used to configure EtherChannel between two switches without
using a negotiation protocol?
A. on
B. auto
C. active
D. desirable
27. How do TCP and UDP differ in the way they provide reliability for delivery of packets?
A. TCP is a connectionless protocol that does not provide reliable delivery of data, UDP is a
connectionoriented protocol that uses sequencing to provide reliable delivery
B. TCP does not guarantee delivery or error checking to ensure that there is no corruption
of data UDP provides message acknowledgement and retransmits data if lost
C. TCP provides flow control to avoid overwhelming a receiver by sending too many packets
at once, UDP sends packets to the receiver in a continuous stream without checking for
sequencing
D. TCP uses windowing to deliver packets reliably; UDP provides reliable message transfer
between hosts by establishing a three-way handshake
28. An engineer must configure a /30 subnet between two routers. Which usable IP address
and subnet mask
combination meets this criteria?
A. interface e0/0
description to HQ-A371:10975
ip address 172.16.1.4 255.255.255.248
B. interface e0/0
description to HQ-A371:10975
ip address 10.2.1.3 255.255.255.252
C. interface e0/0
description to HQ-A371:10975
ip address 192.168.1.1 255.255.255.248
D. interface e0/0
description to HQ-A371:10975
ip address 209.165.201.2 255.255.255.252
29. Refer to exhibit. Which statement explains the configuration error message that is
received?
Router(config)#interface GigabitEthernet 1/0/1
Router(config-if)#ip address 192.168.16.143 255.255.255.240
Bad mask /28 for address 192.168.16.143
A. It is a broadcast IP address
B. The router does not support /28 mask
C. It belongs to a private IP address range
D. It is a network IP address
30. Which network allows devices to communicate without the need to access the Internet?
A. 172.9.0.0/16
B. 172.28.0.0/16
C. 192.0.0.0/8
D. 209.165.201.0/24
31. Which function does the range of private IPv4 addresses perform?
A. allows multiple companies to each use the same addresses without conflicts
B. provides a direct connection for hosts from outside of the enterprise network
C. ensures that NAT is not required to reach the internet with private range addressing
D. enables secure communications to the internet for all external hosts
32. A corporate office uses four floors in a building
* Floor 1 has 24 users
* Floor 2 has 29 users
* Floor 3 has 28 users
* Floor 4 has 22 users
Which subnet summarizes and gives the most efficient distribution of IP addresses for the
router configuration?
A. 192.168.0.0/26 as summary and 192.168.0.0/29 for each floor
B. 192.168.0.0/24 as summary and 192.168.0.0/28 for each floor
C. 192.168.0.0/23 as summary and 192.168.0.0/25 for each floor
D. 192.168.0.0/25 as summary and 192.168.0.0/27 for each floor
33. Which goal is achieved by the implementation of private IPv4 addressing on a network?
A. provides a reduction in size of the forwarding table on network routers
B. provides an added level of protection against Internet exposure

You might also like