ARGA Radio - Description-5
ARGA Radio - Description-5
ARGA Radio - Description-5
Functional description
Interfaces
*EMHH Flexi 3U Casing and High Covers F&B (473187A) are required when connecting
either 4.3-10 straight antenna cables or RET cables. For details, see Flexi BTS Optional
Items Description.
Electrical specifications
g Note: The minimum start-up voltage is -40.5 V DC. If the input voltage is below/beyond
the extended limits, the unit might shut down.
Power consumption
Typical power consumption [W] for 48VDC input, at 25°C, representative of typical
product performance under the same conditions (HW variant, SW version, configuration,
environment, and so on) with +/- 10% margin. Average = (6h low hour load, 10h medium
hour load and 8h busy hour load) /24h
Configurations explained on examples:
• GSM/WCDMA: 2/2/2 = three sectors, two carriers/TRXs per sector
• LTE:
o 2/2/2 2Tx = three sectors, two carriers per sector, 2Tx per carrier
o 1+1/1+1/1+1 4Tx = three dual-band sectors, one carrier per sector per band, 4Tx
per carrier
Some radio units are capable of providing only one sector coverage. Then the power
values in the table consider deployment of three radio units.
g Note: The maximum power reduction (dlCellPwrRed) value is 20 dB. High power
reduction values may cause radio outages.
Installation options
• Pole (vertical)
• Wall (vertical)
• Stack
• Inside cabinet
• One-clip rail installation
Environmental specifications
Functional description