Insta Laci One Stufa

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

HRTP366, HRTP486 Doc #: PGH-HRTP.

01 Revised 22 May 2018 Page 1 of 3


All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated.

Heritage® 36”, 48” Wide PLANNING


Slide-In Gas Rangetop GUIDE
HRTP Dimensions
WARNING
• Observe all governing codes and
ordinances during planning/installation.
(Contact the local building department
for details.)
• The rangetop must be installed as
instructed in this guide.

Chassis Width
Model A

HRTP366 35 7/8” (91.1 cm)

HRTP486 47 7/8” (121.6 cm)

Model B C
HRTP366 36” (91.4 cm) 36” (91.4 cm)*, 42” (106.7 cm)**

HRTP486 48” (121.9 cm) 48” (121.9 cm)*; 54” (137.2 cm)**

* Minimum ** Recommended

Note Description
1 Measured from top of grate to combustible surface.

2 See Cabinet/Countertop Cutout Dimensions, Pgs. 3 – 4.


3 Not applicable for cabinets more than a horizontal distance
of 10” (25.4 cm) from edge of rangetop.

All specifications subject to change without notice. www.dacor.com Ph. 800.793.0093


HRTP366, HRTP486 Page 2 of 3
All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated.

Heritage® 36”, 48” Wide PLANNING


Slide-In Gas Rangetop GUIDE
Cabinet/Countertop Cutout Dimensions

Model B (Cutout Width) D (Hole Offset)


HRTP366 36” (91.4 cm) 16 5/8” (42.2 cm)
HRTP486 48” (121.9 cm) 20-¹³/₁₆” (52.9 cm)

NOTE:
The power cord and gas-supply conduit may
be routed through the bottom or back of the
rangetop chassis.

All specifications subject to change without notice. www.dacor.com Ph. 800.793.0093


HRTP366, HRTP486 Page 3 of 3
All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated.

Heritage® 36”, 48” Wide PLANNING


Slide-In Gas Rangetop GUIDE
Cabinet and Countertop Layout (with downdraft vent)

Model B (Cutout Width) D (Hole Offset) E (Downdraft Vent Cutout)


HRTP366 36” (91.4 cm) 16 5/8” (42.2 cm) 33 1/2” (85.1 cm)

HRTP486 48” (121.9 cm) 20 ¹³/₁₆” (52.9 cm) 43 1/2” (110.5 cm)

NOTE:
The power cord and gas-supply conduit may be routed
through the bottom or back of the rangetop chassis.

Rangetop Approved Downdraft Vents*


HRTP366 MRV3615

HRTP486 MRV48
*Use only the downdraft vents specified.

All specifications subject to change without notice. www.dacor.com Ph. 800.793.0093

You might also like