Scribd
Upload
32 views4 pages

Quotation For CFD Analysis of Heater (Shell and Tube) - SAB

Uploaded by

rahul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
32 views4 pages

Quotation For CFD Analysis of Heater (Shell and Tube) - SAB

Uploaded by

rahul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Date: -03/05/2024

Quotation for CFD analysis of Heater (Shell and Tube)

Scope of Job:

1. All the required input data (as per Annexure A) will be provided by the client.
2. The scope of work includes CFD analysis of Heater (Shell and Tube).
3. Analysis will be performed based on the following:
a. Client will provide geometric data (3D CAD model with all the parts)
b. Client will provide all the inputs as per Annexure A.
4. Analysis will be performed on FloEFD 22.05.
5. The scope includes 02 revisions: R0 and R1
Note: - R1- Load / boundary condition changes only. No geometry / basic design
change.
6. Any changes in the CAD design will be considered as new quotation and will be
charged extra. The amount will be decided with mutual consent.
7. Job Execution: 2 weeks

Commercial offer:

Sr. No. Description Rates (INR)

1 CFD analysis of Heater with R0 and R1 30,000


revision

Commercial Terms:

1. Payment: 40% R0 Submission to client (within 5days) + 40% R0 approval (R1


comment) + 20% final client approval.
(All payments shall be done within 5 days of time line stated above).
2. Only reports will be delivered in the form of soft copy. No hard copy documentation will
be supported. Simulation file will not be provided.
3. The charges are applicable for all the deliverables mentioned in the Annexure B which
will be provided on the support of Annexure A inputs. For other extra deliveries or post-
processing, extra charge will be applicable which will be decided by mutual consent.
4. Charges for revised design: In case of the revised design changes from client
(CAD / geometry change), the same will be chargeable which will be decided by
mutual consent with client.

Prepared by
SAB
Annexure A

Input Required for CFD Analysis of Heat Exchanger

1. 3D CAD of Heat exchanger (STP file)


2. Inlet and Outlet Directions of Hot and Cold Fluid flow (as shown in below image)
3. Inlet Temperatures of Hot and Cold Fluid
4. Mass flow rates of Hot and Cold Fluids
5. Material Properties of Fluids (Thermal Conductivity, Specific Heat, Dynamic Viscosity,
Density)
6. Material Properties of Solids (Thermal Conductivity, Specific Heat, Density)
Annexure B

Output/Results of CFD Analysis of Heat Exchanger

1. Outlet Temperatures of Hot and Cold Stream


2. Pressure Drop
3. Flow Trajectory (as shown below)
4. Temperature and Velocity cut plot (as shown below)

Flow trajectory Temperature Cut Plot

You might also like